Search results

disregard 40-50 ft pounds

Does anyone know the how much torque is needed on a 81 waggy d44 spindle nuts?

Hey I searched and couldnt find a good answer. Thinking of swapping a xj 44 into his jeep but he has ABS and doesnt want to lose it.(I know I tried talking him into ditching it) Would pulling the disk brakes from a grand with ABS work bolt onto the xj housing? Thanks for any help.

Hey there I just did this swap with warn hubs. I went to the junk yard and pulled everything out of a 79 f250 with a dana 44. All you need is the spring, drive slug for the new hubs, axle retaining clip, inner hub assembly and the hub. There is a large retaining ring that holds the inner hub in...

So only 97 and a few 98's came with factory skids? Guess I lucked out then.

yours had a factory skid?

exactlly!

Hey I've never seen one before but my neighbor pulled one off of a 97 for me in the junk yard yesterday. The jeep was 100% stock no modifications at all So I dont think it was from a ZJ. Any clues?

No stock 4.10 in the rodeo axle. From what I was reading was only 4cyl models had 4.56 and my local pick apart has about 20 rodeo a month and for 3-4 months never saw one 4 banger. I asked about the wiring and he didnt remember why he did that. Hopefully the marine core machanics taught him...

Good question thats how I got it

Waggy axle in place coils in place, I set the caster to 5.5 degrees Combination of tj tierod to blazer tie rod wrapped in .250 wall 1.5 DOM to factory waggy steering. Rear rodeo axle installed Zj porportioning valve 1303-27cv shaft installed. FOund out that d44 snouts are longer so factory...

Hey been lurking around here while collecting parts for my XJ. This is my 3rd xj and this one I got for free from the inlaws after their son left for the marines. Its a 2001with about 75000 on it. Had several electrical problems that was from bad wiring from the amp he had installed. Lots of...

FYI rough country long arm kit drops the T case down about 1" maybe a little more. So you will have to shorten the shaft as I just found out.

Hey everyone Ive been doing an intense build up from stock to longarm with d44 front and rear. Before I weld my rear axle perchI need to get the sye yoke on. Would you guys mind verifying before I cut? Im pretty sure its correct. Thanks!!!!

Well I ordered my kit today and it will be shipped around the 10th. So I have to finish my lockers and gears in my 44's hopefully in the next week depending on when they come. So in the next couple of weeks I will be going at it.

I had wj seats then switched to ZJ seats cause I thought they were more comfortable, but have the wj bench in the rear.

Well I would like to pre order one if possible! Ive installed a few of your guys products on other vehicle and always its been top notch!

The only difference with the rodeo is a thicker gear because of the carrier break. Gears are like 20 bucks more. For lockers u have to use a 3.73 and down locker no big deal. Yeah the cherokee 44 bolts in but disks are nice. I have a waggy front so i kept the 6 lug pattern and spaced the rear to...

convienent I can see for someone who cant weld. Still going to have to swap gears either way (some rodeo had 4.56 stock). Other than that I have to politely disagree and I am running this axle myself not a friend of mine or hear say from someone else.

I'm not trying to pick a fight or anything. It seems anything thats different is looked down upon.