Search results

Found a few items leftover from my Jeep. These items are on Craigslist, but pricing here is lower for NAXJA people. Located in Westmont, NJ (outside of Philly). ZJ Alternator I have a Jeep ZJ (I was told this, no part #s to verify) Alternator. Was on my Cherokee for a while before I put the...

Green 1997 Cherokee Sport 4.0L/AX-15/242 VIN: Upon Request Mileage: 170,xxx on the body, 133,xxx on the motor. (I still drive it every day so it will go up a little) Clean title. Title in hand. No accidents. No rust. Location: Westmont, NJ Price: $6000 OBO. No Trades. The Story: The time has...

Tall block from my 97 Cherokee. Has a broken piston skirt in #3 cylinder. 173,xxx miles on the motor. Ran well up until the break. I changed the oil religiously and have notes of when I changed it. When it broke, I immediately pulled over and had it flatbedded to the shop. Not sure of the...

Did some extensive searching today but didn't find a definitive answer. I have a 97 without factory fogs. I have a factory fog switch hooked into the "dummy" plug behind the panel (the one with Orange, Blue, Purple, and Black wires). Problem: Purple wire has no power. Checked with multimeter...

Back story: Broke a piston skirt in my '97 and had a shop swap in a motor from a '96. Just got it back and noticed a crazy amount of rattling when driving. Took a look under the Jeep and noticed the alternator is not bolted in all the way(?) and sitting right on the framerail. I was told it was...

Won this at JITV and thought I would be able to use it, but they don't make tires for my '88 pickup (only vehicle I have that needs tires). Ideally I'd like to trade this for something: 242 H&T SYE 5-90 mains cable kit Gas hood lift kit Hood vent New Black-colored steering stabilizer...

Have a few things from my old lift for sale. First are some 3" Zone nitro rear shocks. Part #7980 (they say 7262 on them but they are the 7980s). One has a small dent on it but doesn't affect it in any way. Cheapest you'll find these new is about $80 shipped. No boots. Installed at 156,790...

Just got word that I spun a bearing in my 97 :cry: so I need to replace the motor. Anyone have a nice used motor or rebuilt motor for sale? Will drive to South Jersey, Central NJ, PA, DE to pick up the right one. Thank you in advance for your help.

Searched and got some info about the 231 but not the 242. Does anyone know the spline length of the output shaft on a late model 242? Trying to plan out my SYE without pulling the DS and measuring. I have an AX15 and 242 so I'm pretty sure I need a 33" driveshaft (collapsed length u to u) but I...

Right now I have a mix n match lift on my 97 (4.0:/AX15/242): Front coils: 3" Skyjacker Rear leaves: 3" Skyjacker AAL Shocks: Zone Nitro. Front valved for 3-4.5" and rear for 3" LCAs: Rough Country fixed length for up to 4.5" of lift Trackbar: Iron Rock adjustable for 3-8" Tie Rod and ends: ZJ...

So after installing my rear tire carrier a few months ago, my rear is sagging a bit with the 32 on the back. The rear of my Jeep has Skyjacker AALs and new Zone Nitro shocks, but it's not getting the job done. I really just want to lift the rear about 1" for the time being, until I decide if...

So I'm swapping out my steering box for a new one and snapped the nipple on the back of my reservoir. Anyone in South Jersey have one? Need it ASAP. Thanks!

Forgot I had these. Were in my basement and I was doing some cleaning today and came across them. I don't have the brackets anymore, just the flares. I only have one of the fender moldings...other wasn't on the Jeep when I bought it. Make me an offer. Located in Haddon Township, NJ. Can meet...

So I keep getting this intermittent howling/growling sound coming from the the front center/passenger side of the car as soon as I hit 55-60mph, and it continues up to 70mph (haven't gone faster than this). I'd say it sounds like when you hit the rumble strips on the side of the highway, only...

Just wanted to pass along some info. Installed a ZJ tie rod a few weeks back and I've been fiddling with the toe several times trying to get it close. Today I put in the IRO adjustable track bar and while I was down there I figured I'd give it a try again. After a few tries I decided to give up...

Have to do front brakes on my 97 Sport. Pads are almost worn to the backing plate. I have done the ThermoQuiet pads on past vehicles and they were quite good, so I'd like to run them now. Question is, they come in Semi-Metallic and Ceramic, so which do I run? I've heard the Ceramic are no good...

Items are for local pickup in the South Jersey area. I can ship for $5 each. If it doesn't say "gone" below, the item is still available. Stock intake elbow. Dirty but no tears or holes. Comes with two stock plastic clamps. Inside is a little oily from an oiled cone filter, so it will need to...

Looking for an adjustable track bar for 3" of lift. Thanks.

I know it's a long shot but looking for a Tailbone. Will pay you MSRP on it, even if it's used. Will consider another rear bumper/carrier combo that will accommodate a 32" tire. Located in South Jersey but willing to drive for a good deal.

Does anyone know what size the 2 stock airbox bolts and 1 nut is? I have tried a few sizes and I've been wrong, so I'd like to save myself another trip to the hardware store if possible. Thanks.