Search results

Lighten up Francis.

Apparently you dont.

You dont have to bend anything.

I rebuilt the 242 in my sons jeep. I did not have any luck with the extractor. I had ordered the parts and kit from Novak. They sent a few sheets of step by step instructions on teardown and rebuild. Lucky for me it had another way of tearing it down as the extractor broke off in the roll...

I have a 1990 limited. When i pulled the engine i did not remove the hood. I just unbolted the small cables on each hinge that limits the travel. Then i took a strap from the front edge of hood to the roof rack and pulled it back so the hood was straight up. It gave me more then enough room...

Yes, I had a broken one that I did not see until I got everything put back together. I used a Dremel tool to cut off the small metal stop clamped on the end. Slid the broken one off and slid a good one on off an old cable from the pull a part yard. Then I clamped a crimp on wire connector...

Sorry to bring up an old thread but i am having some of the same problems. Earthling did you ever get it shifting right?

I just rebuilt my son`s 90 Cherokee with the 4.0 I6. I got a new set of studs from Team Cherokee and reused the old cupped washers. So far, so good. http://teamcherokee.com/exhaust-manifold-bolt-set-4-liter-cherokee-wrangler-1987-2001/

Ok, I have gone through this entire thread and did not see (or maybe catch) an answer to my situation. I have tried the search as well. I have a 1990 Jeep Cherokee Limited with AW-4 and NP242 transfer case. The transmission seems to be shifting and operating fine in all forward gears. When I...

Let me see if I can muddy the water any better. The abs part of the system is not the problem. It works well and even when it does not the only thing you have is an abs system that acts like an old style non abs. The problem is that they used the high pressure system to give the power assist...

I was looking at the OME kit for my 90xj.....is anyone familiar with these and how they ride on the road

Like 87xjco said, the ac dries out the air. Thats part of what makes you feel cooler. It is just like low humidity outside feels cooler.

Hey thanks for the help. I'm trying to clean this thing so i can see but it is like trying to clean up a super fund site!

i replaced those when i did the rear main and valve cover. It does seem to be wet down the sides off the block.

Ok. well i replaced my rear main and valve cover gasket about a year ago. Now its leaking again. Worse than before! Now the question is....Where is it coing from? the valve cover or rear main? How can i tell, this thing is leaking like the Exxon Valdese. When i stop at a light it looks...

Ok...so how difficult is it to replace the bearings in the axle and set it up properly? Is there anyway to check the diff without taking it apart

Dont know about that one but they will do the one on these crazy abs brakes.

I have new motor mounts and trans mount. Could it be the transfer case? I was thinking the chain was stretched and only affected it in reverse. Does that make sense? Drives fine in all forward gears.

I have a 1990 XJ Limited. When I back up slowly everything seems fine, but if I get on the throttle while backing it acts like its binding in the driveline somewhere. It does it even worse backing up hill as I give it more throttle. When I back up my drive way it feels like its locking up and...

I ordered the material and glue from WLS headliners. They sell the kit with glue and I upgraded to the more expensive glue. when I ordered the kit I added more material for the console and visors. I have more then enough but I always think it is better to have too much then not enough! The spay...