Search results

So how did the project go? You found the seats from the 2-door, and I'm assuming they bolted right down to your 4-door XJ? Or did you have to unmount the seat and bolt them down to your 4-doors seat mounts? Sooo looking fwd to this same mod. thanks

Thx for the tip And good for getting rid of an unwanted vibration!

Hi all - Ive had a Hanson rear bumper with spare tire carrier for a few years now with no problems. Recently however have been hearing a popping noise radiating into the cabin. Appears to be coming from under the floor of the rear cargo area. Happens when going down bumpy roads and also I...

That's what I was thinking. Wondering if it is even a possibility. A friend said that sometimes there may be a T-case shaft misalignment and it's putting pressure on the speedo gear and sleeve causing it to get chewed up. However, I have zero other symptoms. Curious.

It was. It worked for a good 20k.

[/IMG] having trouble with the first image. Let's see if this works...

Forgot. :) 1998 XJ 4wd 4.0 4.56/32” Also if note, that speedo gear probably had 20,000 miles on it. Is it possible for a VSS to fail in a manner that would prevent the speedo gear from spinning, and would then rip up the teeth on the sleeve?

Hi all - Any ideas as to what could cause this? Highway driving and speedo/odo quit and threw the P0500 code. Had a guy pull the SYE tail housing off and he found that the speedo gear and the gear sleeve were both chewed up all the way around. No other symptoms. Put a new gear...

Hey - did you ever resolve your issue? I've got the same problem with my '98. I ordered a new pump from PSC, failed right out of the box as it dripped fluid which was then spread throughout my engine bay. Ordered a replacement (which they speedily sent out - thank you!), however I'm still...

It's good to check up on people. Never know what crazy stuff they come up with. PSC contact will happen tomorrow. thanks

You mean besides my 3lb sledge?? Just kidding. I used this kit from O'hannigans http://www.oreillyauto.com/site/c/detail/OTC0/4530/N2411.oap?ck=Search_N2411_5014060_3141&pt=N2411&ppt=C2371 I made sure that when I was installing the pulley and cranking down the large nut, that the main bolt...

Prime the pump? I did not do that. There were no instructions. After pulling the center coil plug so that only the starter motor would power the pump, turned the key and I noticed a significant drip coming from I think the front of the pump behind the pulley. Hard to tell exactly. (i'm...

Ok - so I replaced the O-ring. When I fired it up, again, a fine mist spraying everywhere! I couldn't see where it was coming from as I was turning the key. The fitting at the pump to the high pressure line is dry. The fitting and hose at the return line is also dry. Where else could this...

Hi all - It's Sunday today so wanted to get info from all of you before calling PSC on Monday. 1998 Cherokee XJ I decided to replace my stock power steering pump with PSC's SP1205C pump. (97-'06 4.0 TJ Replacement Pump w/ reservoir). This is what they recommended. I decided to use my old...

ok - good. Thanks for the information. I've put the suspension into full crunch on one side and full droop on the other (as far as I can tell I've maxed it out). The way that I've currently got it set up, on the crunch side I've got 1" until the bump stop hits. I'm measuring 18" from the...

Hi all - I'm replacing my front shocks and am not quite sure I've selected the correct replacements. I've got an old Rubicon Express 4.5 inch (6130) Superduty lift with 32" tires on my '98. Old shocks were: Rancho 9000x The fronts are either the 99255's, or the 99256's 99255...

what a sweeeeeet rig! Couple of questions: What does it weigh before you have it packed to the rim? What does it weight after - approximately? And have you pulled it on rough terrain? Any comments as to how it handles?

actually, any and all information is welcome. The mileage thing has me questioning whether its the right jeep to swap stuff over to. Maybe should wait for a lower mileage vehicle to come along. I dunno. Just thinking out loud. Clean body, nicer interior, manual windows/locks - is that...

Hi all, I've been driving my 2001 with a 4 1/2 Rubicon lift for some time now, and have been considering a suspension swap to a cherokee with fewer miles. Here are the stats: Mine: 2001 4 door automatic transmission automatic locks/windows 180,000 miles 4x4 used lots. Lift installed at about...

Hi all was having intermittent power window/door lock failure and now this is happening: Recently (until JUST now) passenger side wouldn't roll up. I now have control for all windows from driver's side I have control from driver's side only for all windows, and the rear windows work at their...