Search results

So I have a trade for someone else wanting co2 oba. I have an extra, full 20 lb aluminum co2 tank ($130 at air gas) I will trade it for 150psi regulator $40 http://www.eadoffroad.com/poly-performance-ppi-2302-02-co2-fixed-regulator and tank bracket for 20 lb tank $50...

It is going to be on the face

I'm guessing off hand that it is about 12x18. I can remove the cover and bring it into someone.

It is sheet metal. I have a gate control that I need blanked. I got a sheet of stainless to do it. I want it to look nice because it is the keypad to get into my neighborhood. This is the cover I am blocking off. I am going to strip all the raised stuff off of it so it is flat.

Anyone in the Portland/vancouver/woodland area set up to weld stainless? I have two pieces of stainless sheet metal that I need attached

After venturing up in the snow last weekend, I figured that I wanted to get a group together so I could go further. A couple phone calls and a week of anticipation later we headed up. I didn't get a lot of pictures, I'll leave it to Dustin to post his torx report Dustin's high steer arm went...

Knowing your limits, and and being prepared are key. Scott, the snow cat ride sounds fun

I think I should go too

I'll bet that is the same set, I just opted for the 5 way roller switch.

I bought this kit off eBay http://www.ebay.com/ulk/itm/281380372657 At first they wouldn't work, I trouble shot it down to a faulty switch. I emailed the seller that the switch didn't work, he sent me an entire new set and said not to send anything back. After replacing the switch they work...

Well I decided that seat heaters were more important then actually solving my death wobble

I'm leaving from work at 6:55 am friday

From Darren

http://autoweek.com/article/car-reviews/2014-jeep-wrangler-unlimited-dragon-edition-review-notes

The Clayton 3link kit is much beefier and better for the northwest then re short arms

Lol $9000. Only the best... Short arms at 5.5" lift and a open d 30 up front? This is a 5k cherokee.