Search results

Were you able to solve this problem? If so what was the solution? Thanks

Finished up the replacement tonight and it seems to run and idle better then before. sjkimmel99 thanks for the link - I had read that before I posted but I did refer back to it during the install. I had to trim the bottom of the intake on the #6 cylinder for clearance and I also got the felpro...

Should I also change the 0-ring on the fuel line? Thanks

It is time to replace my cracked exhaust manifold on my '99 XJ, 4.0, auto. 4x4. I have an APN on order and this is going to be next weekends (hopefully only 1 day) project. Are there any tips or secrets other then remove and replace per the FSM? I will spray PB Blaster on the nuts and bolts...

My '99 starting making a noise under load when warm. Turns out my exhaust manifold is cracked. Take a shop vac with the hose on exhaust and get someone to hold it on the exhaust pipe and feel around the bottom part of the manifold - just above where it connects to the crimped pipe. I have a...

bump

http://www.steigerperformance.com/

PM sent

PM sent

I have pulled a 5 x 8 U-haul trailer a few times and it was no problem. I have wondered how the larger trailer would pull because the next time I help my daughter move I think we will need the larger one.

Marchel comes to mind with that logo

Anybody btt

Do you think this would do at least as good of a job as the Mopar part: http://store.summitracing.com/partdetail.asp?autofilter=1&part=THE%2D17062&N=700+115&autoview=sku I was planning on doing all 6 injectors. Thanks

What kind of insulating material would be good to wrap the injectors with other then buying the kit from the dealer? I am having this problem and decided that I would wrap all 6 injectors and maybe the fuel rail also instead of just the #3 injector. Thanks

My passanger window went last November and the drivers window went in May

The above listed repair route is the way to go. I did my drivers window a couple of weeks ago - took less then 2 hours and saved around $150.00

From what you posted I would guess that it is starting to break. If it does break and the window slides down in the door then you will have to take the door panel off to get the window back up. I would take the regulator out and apply power to the motor and see if it runs up and down ok. It...

I just installed the part for my drivers window. Cost around $30.00 and around 2 hours time plus the time to remove and reinstall the regulator in the door. I used the hose clamp to keep the window up while I waited for the part to arrive. Ordered it on a Wednesday night and it was in the...

Read the above link - I just installed the part for my drivers window. Cost around $30.00 and around 2 hours time plus the time to remove and reinstall the regulator in the door. I used the hose clamp to keep the window up while I waited for the part to arrive. Ordered it on a Wednesday night...

When mine ripped I took a plastic milk or OJ carton and cut 2 pieces of plastic, put 1 on the botton and 1 on top of the splash shield and stapled them together. I also reinforced one of the mounting holes that way also. So far so good - I did have to redo one of the mends but it seems to be...