Search results

So, I noticed my rear diff was wet with fluid. In vestigated and found it to de diff fluid from the pinion seal. Is this something the average home mechanic can tackle? Looks like, according to my FSM and using the 8 1/4 as a reference, a couple of specialty tools are needed as well as fairly...

Okay, here goes; 96 Cherokee with a Dana 44 rear and Dana 30 front, 5 on 4.5, 15x8 steel rims, BFG 33x12.50x15 T/A's. Had a bad wobble so took it to Discount Tire, where I bought both tires and rims. There was a huge balance issue on one tire, but after checking they found all four to have the...

looking for replacement rear lower shock mount bolt, nut and washer. jeep dealer told me they are only available with a complete axle purchase. it is an aftermarket D44, but they look the same as the 8 1/4 type and I am almost positive these are the stock ones taken off my old axle and welded...

I saw a lifted white Cherokee with dual hood scoops in downtown Spokane the first week in January. Just wondering who you are and where or if you go offroadin' around here. Thank you

just started hearing this noise and have narrowed it down to under the vehicle. noise sounds like a high pitched squealing and only happens while in drive or reverse. when in neutral the noise goes away, so I do not think it is the brakes. I checked all the fluid levels tranny, oil, transfer...

A while back there was a good write up for installing a switch to turn on the aux fan manually, that included a diode. On the 96 and newer it is ground activated, so I was a little confused on what I found when I searched. Can someone please clarify the wiring and parts needed. Thank you

What would cause the diff fluid to be sucked up through the ARBair hose? When I deactivate the ARBthe puge of air also has diff fluid in it and a lot. It is acting like a straw. I do not use it that often and I was just testing it to make sure it still worked. I am also getting ready to do...

I just noticed this and do not know if it is normal. I have a 1996 Cherokee, 4.0l, automatic, 4x4. With the selector set in the vent position and going on a flat stretch of road the air come out of the dash vents and the floor vents. However, when I go uphill the air shifts to the floor...

I have Rancho 9116, that I need to replace the bushings on. 1) Does anyone know if they make rubber replacements and if so where can I get them? 2)Where do I get factory replacement poly ones? 3)Can I do these with basic hand tools or do I need a press or something special? Thank you

Anyone know if the bushings in the shocks are replaceable? If so have you done it yourself and how? I have the original poly and they are oblonged and almost worthless. There is a banging noise, like a loose part, from the front end and I am attributing this noise to the worn bushings. I have...

First off I blew it now I pay the price. I had a switch hooked up to a Compu Shift, this device is supposed to do what has been done here by others, keep the vehicle from shifting from 1st to 2nd. I got the wires mixed up and now it will only shift through the gears manually. I figure I fried...

has anyone switched out the standard single dome light for the dome light with the dual map lights? I looked into doing this, but it seems that something else is needed to mount it to the headliner or roof. any help is appreciated. Thank you.

Has anyone installed an engine block heater, factory part, but after they bought the vehicle, not a factory installed option. I moved from California to a snowy cold climate and want to install one of these. I have done the research on parts and installation in the manuals and online. When I...

Are there any XJers in the Spokane area? Where do you go for off road fun?

Anyone know how to/ the procedure to test the oxygen sensor heating circuit? I installed a new set of O2 sensors and now have a malfunction in the upstream circuit. I replaced the upstream sensor at the suggestion of a mechanic, because it read too high of voltage. I then cleared the code/MIL...

I replace both oxygen sensors and now am coming up with this code:PO132. I have erased it at least 3 times and it keeps coming back. This is not a daily driver, yet, and thus anything as far as gas mileage difference and the like is not useable for comparison. According to the book that came...

Has anybody bought one of the CDs, listed in the Vendor section, that has the part numbers? I was curious if that was as good as the counter guys have or if there is something better. Any feedback is welcome.

Anyone installed one of these and found that it does not seem to fit right? I got one that does not bolt up. I could oblong the holes, all of them, but for $80.00 plus shipping, I should not have to. Any thoughts beyond calling them to complain?

I got a new CSF radiator from Dirk at DPG Offroad, great price,delivery time and a nice guy, and it is a little different than the stock and other aftermarket units. I have a 1996 Cherokee with the 4.0L and an automatic. The original tranny lines have a metal elbow at the end of the...

Anybody have anything to say about any type of code reader/scanner? I am talking about the type you plug into your computer to read the check engine light messages. I know about the ability to read the codes without one, but it would also be useful on the wife's car too. What is the difference...