Search results

2000 I need new rotors and pads really bad. Could this be it?

I have a 2" RE BB. It has been on for 1.5 years. I hate it but I don;t have the $ to do any better.

None that I have noticed.

Only notice it at slow speeds like in a parking lot. I have a wobble from the front passenger side. What could this be?

...

Replacing ujoin on rear driveshaft. I have a press. Can not get cap off of ujoint in order to remove it completely. Suggestions!

10 mm with 1.5 pitch

I don't have anywhere I can go. :(

How long did it take to settle?

If I remove the rear swaybar will it drop any?

Tires won;t matter when measuring from the center of the hub. But yes, same tires.

I would not have gotten it had I known. Before lift I was at 17" from hub to flare and now 21" on a full tank of gas. If I throw in 300lbs of sandbags I am at 19.5" with horrendous gas mileage.

I will probably end up doing a TC drop. I don;t have the finances to SYE. :(

Full

I lifted my stock 2000 back in October. I used the 2" RE BB with full length AAL's. I ended up with 4" on the rear so I had a significant rake and driveline vibes. After a couple of months is still had not settled any so I threw 300lbs of sand in the back hoping it would help it settle...

Yes. Why buy more than I need. I already have everything up to 19mm.

Socket size needed for shackle bolts?

A little lower? The rear end is now measuring at 21" from center of hub to bottom of the flair :s

I recently installed an RE 2" BB with Full length AAL and my jeep now has it's a$$ in the air. How can I fix this? I would much prefer to bring the back down than to raise the front higher.

XJ T-Case drop kit shipped to 64063?