Search results

my 97 cherokee has been making a weird noise for a couple of weeks now and its getting really bad. its like a howling noise, and when it gets real bad, makes the steering wheel buzz. it varies with rpm and can even get harmonic (bzzzz.....bzzzzz....bzzzzzz..) any ideas? i have an idea but i want...

my front passenger ujoint was obviously going out, so i figured thats what the noise was. just finished up changing out the ujoint and looked forward to a nice quiet ride, but nope. still howling away. its a roaring noise that seems to come from the passenger front side. any ideas? wheel...

i just noticed this today. i had the heater on, and i slowed to a stop, and there was a vibration from the engine like the idle was high, but the idle was normal, as were all of the gauges. it would vibrate, then stop.. and then start vi when i turned the heater off it seemed to stop. have you...

I'm thinking about getting some 34x10.50 LTBs to replace my ripped up 33x12.50 MT MTZ's. the rocks around here are too sharp for the mtz sidewalls, and the LTB would be my cheapest option. what kind of life are yall getting out of them? my daily commute is only about 3 or 4 miles to and from...

So yesterday i finally got to try out the new drop bracket system with my rustys offroad 6 1/2 inch lift. It ROCKS! i was doing all of the level 3 and 4 trails no problem with only a positrac in the rear end. the front end is super flexy now and keeps the jeep planted on the ground and...

oreillys strikes again. those morons think i have "cv joints", not u joints in my axle, even though i went outside and showed them what i'm talking about. i need the part number for the 297x ujoint outer ujoint at the wheels, and i was wondering if there's a certain ujoint that'll fit without...

I need the stock control arm bushing part numbers so i can send my wife on a parts run to oreilleys to rebuild my front end this weekend. i need all of the bushings basically, upper and lower control arms and track bar. thanks in advance! i went to oreilleys and they didnt even really know what...

i have a 97 xj with a 6 inch rustys lift kit on, porc sye and cv rear driveshaft. i decided to take off the transfer case drop to see if it would improve my drivetrain angles now that i have an sye. indeed, it doesnt seem to vibrate as much. however, now there is a loud clunking/rattling noise...

While under the jeep fixing the broken upper control arm mount, i noticed that there was a hole in my flexplate? i checked my oil and transmission fluid and both were still up to spec.. what should i do?? here's a pic. i need advice immediately!

so i flexed out the jeep a little on my property, and wasnt getting much, and then POP and got alot more flex. now, what should i do? just get the mount rewelded, get another mount or what??

My jeep's got a couple issues. First, the tierod on the passenger side has the bushing blown out. Also, the bushing where it connects to the pitman arm is worn out. Is it possible to just replace those bushings? if not, what do i need? looking on rusty's offroad just has me more confused as...

I need to get a SYE/CV driveshaft for my 97 XJ np231. I looked at rusty's offroad but shipping is a B*tch there. ebay? any other stores a little more reasonable on the shipping? i need this stuff bad, and i'm going to order either today or tmrw. let me know!

i'm trying to figure out what it is.. there's no id on it, all it says is S. Africa on the stinger which leads me to think its a brand, not homebrew.. the sliders also look similiar to the front bumper. i'd like to find out if there's a rear bumper that goes with it, so i can see what it...