Search results

She needs a new home!! http://portland.craigslist.org/clk/cto/5085252545.html Thanks for looking :)

Hey all, my 87 4.0 with a manual tranny has developed a grinding issue. On occasion after startup i hear a grinding sound coming from the transmission tunnel. It doesnt matter if its in neutral or in gear with the clutch in, so i thought maybe there was something wacked out with the starter...

I recently installed adjustable upper and lower control arms. While installing them I noticed the bushing on the new arms were slightly wider than the stock ones. Installing them took some....finessing (and ALOT of grease), to say the least, but I got them all in and snugged down to spec. Of...

I need a new one, and seem to be having an issue finding one that works. The first one I bought from autozone and the jeep idled at 2500 after putting it in. Thought "well, maybe it was just a dud", so I exchanged it and the second one came all unscrewed in the throttle body and I had to pull...

Im in the process of changing my evap and heater core and noticed the new evap core doesnt have the hole for the capillary tube. Is it possible to bend the tube and put in the fins on the side? Or is bending it gonna cause major issues? Thanks

Went for a drive today and noticed a hissing from under the dash where my evaporator core is located and the compressor wouldnt stop running except for a couple of times. The hissing takes a couple of seconds to go away after the ac is turned off, and goes away (albeit rarely) when driving down...

I noticed over a road trip the other weekend that when I run the heat on my 87' my dash gets VERY hot to the touch. Almost hot enough that I think twice about touchng the radio cuz it might burn my finger or something. Is this normal or is the sealer stuff thats supposed to keep the heat going...

I wanna purchase a set of the v2 fender flares (merry xmas to me :D), and have a bit of a question that the guys at napier cant answer and thought maybe somobody on here could. I have an 87 and did the rear are cut and fold thing, but the site only sells the cut and fold option for 97-01...

Hey all, My 87' is currently sitting on 3" of lift and I have the itch to kick it up a little higher (roughly to 4.5-5"), but am questioning the easiest, cheapest, and best way to do it. Ive thought about using coil spacers and shackles and then just ordering everything else needed...

I refuse to put airtex anything in my jeep and just need the sending unit. Was told by the dealer they dont make the sending units for my jeep anymore :bawl:. Anyone know of a decent aftermarket fuel sender or where I can find an OEM one for an 87 4.0? Thanks, Me

Am I correct in thinkin that if I pump the brakes and my RPM,s rise that means there is a leak in the brake booster and its time to upgrade?

Hey all, I just replaced my cracked exhaust manifold with an apn header and now im having an issue with a manifold leak. I though maybey the gasket was the issue so I went and bought another new gasket, took it apart, and replaced it for the second time today. The leak is right underneath the...

Just finished the disk brake swap on my 87 with a 44 and took it for a test spin. Im hearing what sounds like metal on metal that gets louder the faster I go. It doesnt make the sound below 15-20mph, seems to go away when I turn to the drivers side or am accelerating. Ive taken everything...

I decided to go the explorer route for my D44 after reading numerous different forums about the swap. So Ive got all of the parts to do this except the soft lines. My first question is do the threads off the exploder lines match the ones on our cherokees? And if not is it possible to just use...

I finally took my 87 xj in to have the a/c system vaccumed and recharged because I never had it done after I put in the missing parts and got tired of the intermitent cold to warm air. So after taking it in and being told that the system holds pressure like it should, having it vaccumed and...

Ok, maybe love is to strong of a word, but I saw these doors and want a set too...Anyone know who owns them, or where they can be had?

Was lookin around the local yard today and didnt see any tire carriers on any of the blazers, but there seems to be an overload of isuzu rodeos with them. I took some rough measurements (very rough), but from what I can tell it seems like they would work size wise. Was wondering if anyone has...

Lately my power steering has been cutting out, but only when Im exiting the freeway and am turning a corner at the same time. It doesnt do it all the time, is very random, and the jeep is still running with everything working. Am I correct in thinking that the PS pump is just belt driven and...

So, my jeep has been plagued with slow wipers, especially on high and after researching I finally found a fix for all who also have this issue. What I found is that you can switch out the motor from a dodge dakota or jeep grand cherokee...the motors in these vehicles happen to be noticably...

Ok, Ive been tinkerin with my stupid wipers for a few months now. They work, but are really slow. They actually work fine while in the delay mode, but on low they slow down, and on high they go even slower than low. Tested the power and get 12v+ where im supposed to depending on where the...