Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I have searched but not found my answer. I have an 01. Last winter the wiper motor shaft corroded so much the motor would turn so slow the wipers moved slower and slower until they finally seized. The motor overheated and I had smoke rise out of the motor. I removed the motor, stripped it down...
This all started after the detroit truetrac went in. Whats happening is the truetrac must be slightly different around the area where the C clips fit in, therefore allowing the axle to move in and out a little more than the usual 1/8 in or so. The knocking noise is halfshaft outer hub knocking...
My 2001 leaf shackle bushes need replacing. I have a 2.5in procomp lift fitted, im thinking about fitting daystar greaseable super shackles giving me an extra inch of lift at the rear. Would this cause any additional problems or will the jeep be up too high at the back. The jeep is stock apart...
Replaced both rear upper shock bushes as I had a knock from the rear end when I bumped up a kerb, so t's gonna do it when i'm on the trail, kinda like the sound you get when your exhaust hits the frame or whatever. We'll after a nightmare day, it still does it. Everythings tight under there...
I am about to install an electrical accessory into my 2001 XJ. The accessory I will be installing draws 0.06 amps when not in use. It will drain the battery even when it's not in use unless I switch it either with a simple switch or through the ignition switch.
In the installation...
My LSD clutch plates in the rear axle are chattering when I pull off from roundabouts. I need a new rear diff. I have a few options but any advice is appreciated.
I live in England so good low mileage second hand axles are hard to come by, and new parts/labour are relatively expensive.
1)...