Search results

OK, here is one for the Brain Trust (tm). I have a 96XJ. I found the shorted wire which originally caused my lights to short out; it was the right front side blinker. I also replaced the "clicker" relay under the dash. What I have now is this: 1) Light switch off - left blinker is fine, right...

I got an issue with my 96 XJ 5speed. This evening while driving around, I came to a light and popped it out of gear. I go to put it in gear - the clutch pedal went to the floor with zero resistance, but it went in to first and did NOT want to come out of gear. I had to shut off the engine to get...

I've got a 96 w/ an AX-15, stock 3.07's on 32" M/T's. I have a set of 3.55 auto axles sitting around. Is the swap worth the time? I know 3.55's aren't much higher, but they got to be some what better than 307's. I did do the gear math thing on tire size, and came to 3.63, so its pretty close...

This will be happening in about a month. I got no problem putting the tranny in, it is the electrical part. If I don't use the TCU, but an AWShift unit, do I still need to pick up a speed signal from somewhere, or is this purely a TCU requirement? As far as sensors, I can't find any on the...

I'm looking at a set of T&T upper adjustable arms; the price is more reasonable than RE of the same thing. Anyone have them? I know T&T build a good y-link kit, but I can't find anyone using these. Any issues? Long term reports? Anything at all, thanks.

I lifted my XJ, put new tires on, drove 50 or so miles. The inner sides are both showing wear on the front, so I measured the axle tube at the pumpkin and behind the knuckle; it drops a third of an inch from knuckle to pumpkin. Assuming the parking lot was level, I take it this is why i got...

Got a 96 Sport, 4" lift, probably settling below this, w/ RE lower fixed arms, but stock upper. Would this arm combo cause significant enough caster issues to cause negative camber? Should I put the stock lowers back in?

I have need of a 91+ Cherokee so I can make a running one I can drive on the road. Will take 2/4dr auto/manual, whatever. It can even come interior, can have scratched/faded paint, but shell must be straight with no major issues or heavy cancer. Will consider a running Cherokee on its last...

I have recently come into possession of two Cherokees and need to decide what to do with them. I know what I will do, just not to which one. One is a 90 Briarwood, 230,000mi, automatic. Has the fulltime/parttime transfer case, all power options. Rear passanger side is slightly crunched behind...

Tapco hub/bearing assembly Hi, first post, need some new front bearings for the $200 Cherokee. Both the front ones are shot. I found the Tapco International ones on Ebay, but it only lists the 4WD Cherokee bearings they sell as going to 1993, I have a 1996. Are these mislabeled on their sell...