Search results

ok so i did some searching and i think this is a ground issue but i wanted to get more info based on my exact issue. on my 2000 XJ when using the left blinker the rear hazards come on, front is normal. the right blinker works as normal. hazards work properly. i did swap out my combination...

Looking for a transfer case shifter and handle. "Z" shifter I have heard them called I guess but does anyone have one laying around from a part out? It's the last piece I need from my 2wd swap. Shipped to 04038 Gorham, ME

while driving, get to a light or stop sign and start to go again the jeep will stumble over itself, revving up and down but not going faster with throttle input. give it a few and it's fine again. no CEL. TPS? other sensor issue? drives perfect otherwise, very intermittent

i know 00 and 01 have slightly different unit bearing and rotor widths than the older ones but if i swap them both to a zj 30 will the calipers then line up correctly? :dunno:

helping my buddy sell his mustang if you're a serious buyer PM me and i'll give you his number located in West Milford, NJ VIN: 1ZVBP8CF2B5134885 2011 Mustang GT 5.0/6 spd manual 25xxx miles American Muscle 93 octane tune Airraid intake Magnaflow axleback California Special grille, lower...

for a 99 4.0... does anyone have the rear crank case vent, elbow and hose this little bastard, for the rear of the valve cover the one at the rear also if anyone has the 4wd lever and bracket i need it for a 4wd swap

selling my 1991 car trailer. i think the manufacturer is cooper? i have to double check but the title says CO/CR for make. dual 7500lb axles with good brakes full steel deck with dovetail and ramps. perfect for my jeep without the ramps and can fit low racecars with the ramps as well. good...

23 spline.. looking for one near north jersey. preferably close and within the next week or so if possible. anyone know of one laying around?

i need a 97+ rear hatch glass. preferably close to northern NJ if possible

i'm selling my 2002 jeep grand cherokee limited. 99k miles. patriot blue with tan leather. it has the 4.7 high output V8, automatic transmission, np247 transfer case with quadradrive which has the varilock limited slip diffs. leather, heated seats, auto mirrors, dual climate control, moisture...

235-75-15 goodyear wranglers on dark gray ecco wheels. they are a little dirty but it good shape. i'd say 70-80% tread. $275obo

i'm selling a set of Rustys steel tail light boxes with LED's and all wiring. i bought these brand new and had them on my jeep for maybe a month. i only drove it probably 4-5 times in that amount of time so they are pretty close to brand new. asking $200obo shipped for everything

i have a set of 3" Rustys coil springs in great shape for sale. $75

i'm selling my 91 comanche eliminator. 4.0 HO with 107k miles on it, ax-15 trans, 2wd, long bed, very very little rust. this would be a perfect project for someone building a hardcore trail rig or even to restore to new. the truck drives great but i'm DDing my 96 xj so this has to go asap. the...

looking for transfer case and gas tank skids or belly skid for a 97+ XJ with np231 please PM with offers

looking for transfer case and gas tank skids or belly skid for a 97+ XJ with np231 please PM with offers

i need to replace the bushings in my long arms before i install them. i found these flex joints, same as the ones in the RE super flex kit i believe. would ride quality and fit be good on rustys long arms? should i use just flex lowers and stock bushings all around or flex joints in other...

well i'm at a loss. i have a bad clunk and slight wobble everytime i hit a bump or pothole, as well as vibration in the front end. i'm running a rusty's 4.5 kit with adjustable lowers, stock uppers and 3/4 spacers to level it out. within the last month i have installed the TNT steering system...

hey everyone, i've been lurking around here for some time learning all i can. well the time finally came to lift the xj. finished last night around 5am. here are a few camera phone pics till i can get some good ones. next up is trimming. Rusty's 4.5" with 33" ProComp MTs and Soft 8's much...