Search results

SOLD

sale pending

No thanks on the trade. I don't have anything that yours would fit and am only getting rid of these because the "Heep" as my wife calls it, is getting sold.

I work up at O'Hare. I should be able to come up with the receipt. I got them from discount tire direct, so they should have no problem at discount tire for warranty purposes.

4.0L Runs great, does not burn any oil. It is located in the western suburbs of chicago. Glendale Heights, IL 60137

Just as the title states, Four brand new never mounted BFG All Terrains 31x10.50.15. I purchased them for the XJ that is for sale in the another post. Located in Glendale Heights, IL 60139 $450 Firm

'93 Cherokee 163,000 miles, 1600obo Located in Glendale Heights, IL 60139 I've got a new little one on the way and can't afford to keep her! 4wd works great A/C works great Rock Rails Front tow points Transfer case skid plate Gas tank skid plate (not installed) Sway bar disconnects (not the...

If you put your kill switch in line with the yellow (on mine at least '93) wire from your ignition switch you will get the no crank that you are looking for. This is the command wire for the starter relay which in turn commands the starter solenoid. Also handy that if it dies for whatever...

Great writeup! Looks good, glad it worked for you

Yeah, thats pretty much what I did on my '93. I wouldn't go back! before after

Exactly what I meant too. HP is nice for Car and Driver and MotorTrend, but Torque is where its at!

238hp and 159lbft (2005 rx8 couldn't find 06) vs. 190hp and 225lbft? Easy choice for me.

I have, I used the template to mark out on cardboard and adjusted to fit. By measurement, the holes lined up well for me. Pass side Driver's side

I appreciate all the help. I will redrill for 1/2" hardware, new angle so the bolt hole won't be so close to the edge and put a plate across the front (I really like that idea). It should really stiffen up the front end and like I said, I would like to use it all as a base for a bumper later on.

I saw a pic of one like that and didn't care for the look. I know I'm giving up clearance but I'm not that concerned. That is my question. I could move up to 7/16" bolts or should I go up to 1/2"? As for the angle part that bolts thru the cross member, the idea was for lateral...

Did you bench bleed the MC before installing?

It took much longer to make than I thought it would. Mostly it was finding a 1" drill bit that would get through the 3/4" plate that wasn't $50+ Lowes had their Hitachi brand bits and it was only $26. It is still sharp. I did tie in the steering bolts on the other side. It looked easier...

I did a ton of searching and came up with these as my front tow points. I hope to use the setup later as the base for a new bumper. The plate is all 1/4" steel with the part that the shackle bolts to as 3/4". The hardware is all 3/8" grade 8. My main question is whether the 3 3/8" bolts that...

http://www.naxja.org/forum/showthread.php?t=906034&highlight=headlights Thats what I've got and they are great! Much less than $50

PM sent - Sliders