Search results

How can I tell if the cps is reading off another flywheel I installed Does it just open and close like a switch and can a volt meter see this if you crank the engine

I looking for someone i could hire to trouble shoot a wiring problem. Here is the run down. I rolled my 97 xj with a good working engine. I installed the engine in my YJ . All original wire harness and dash. This should just be plug it in and start. The engine cranks but no spark and fuel pump...

I just put on a high pinion front axle from a 97 on my 2001 which had the low pinion front axle Now the driver side wheel sits out about an inch further than the passenger side Anyone else had this happen ?

Looking for a tube bender in the LA area I just need 2 pieces of 2 in. Tubeing bent into a U shape

Just rolled my jeep looking for a replacement 97 or newer If anyone in the area knows of one for sale let me know. preferably green

I need to replace the down stream 02 sensor. I see some universal ones for $30.00 and then some for up 2 $80.00 Are the cheaper brands just as good as the expensive ones?

97 auto 4.0 215,000 miles original engine my jeep only leaks oil when the motor is working hard such as going up a long grade. after several minutes of going up a grade I will notice smoke out my rear window and specks of oil on the rear window. when I stop and look under the vehicle there is...

Has anyone had success pop starting a automatic Cherokee or is there any other way to start it if the starter goes out

looking for a right front fender flare. unpainted black 97 cherokee. anyone have one laying around?

how do I determine the length of my upper and lower control arms. I have adjustable arms. I think its a matter of getting the axle sitting correctly but what is correctly

will a 98 isuzu trooper with 3 inch lift, 33 inch tires, terra low transfer case, arb rear locker, do the trail. i would have 6 days to finish the trail so i can take my time

I get a whirring sound from the bellhousing area in drive or reverse. I dont have to be moving. When I shift to park the noise goes away. any clues? does the torque converters go out? 1998 4.0 cherokee sport, auto trans just turned 200,000 miles

My front end has been bottoming to easy latley, Any way to test if the bilstiens are gone? they are 2 years old. My RE front coils are 4 years old> I am not sure what to blame it on

1988 4.0 only heats up when climbing a grade. It has been converted to an open system. 3 row radiator about 2 years old. fan clutch seems to be locking up when hot. I have the electric fan on a switch to run it when I need. At idle it wont heat up with the electric fan on. city or highway...

I am replacing my fuel pump on my 97 XJ. Should I stay with a dealer part or is there an aftermarket unit that is better?

what size tubing goes around the head light on a arb bull bar? If anyone knows or has one on there xj and can measure the diameter for me and let me know. thanks

does the tps sensor have anything to do with reverse? the reverse went out on my aw4 trans. so I thought. swapped in a different trans from a jeep salvage yard and now I still have the same problem no reverse. if I stomp hard on the throttle it will lurch a little but other than that it feels...

my 88 with automatic and 150k lost reverse yesterday. it had been shuddering for about a month when I put it in reverse and would not have enough power to reverse uphill. now it acts as if it in neutral when in reverse. fluid is at correct level and dosent smell burnt. anyone have some...

my 88 with automatic and 150k lost reverse yesterday. it had been shuddering for about a month when I put it in reverse and would not have enough power to reverse uphill. now it acts as if it in neutral when in reverse. fluid is at correct level and dosent smell burnt. anyone have some...

can I get 32 bfg mud terrains on 8 inch rock crawler rims with 4 inches of lift? anyone else have this set up? how much trimming will need to be done?