Search results

I have plenty of heat coming through the ducts, but like if I go 75-80 mph, my engine gets to hot. I know there is antifreeze in there. Also, different problem, when I start my jeep up after it has set for a couple hours it starts fine. But if I drive it for like ten miles and then go to turn...

I seached, but didnt find anyone that used a 97+brake booster and MC. I know the push rod is a lot longer, but if I use the pedal from the 97+ will it be an issue? :confused:

Drivers side fender Grill Header panel Headlight bezels Drivers side front turn signal Drivers side rear turn signal Black bumper Drivers side black bumper end cap Let me know if you can help me out. Thanks, Justin :anon:

So, I bought an Aussie for my D44. One problem though. My crossshaft will not clear the ring gear. If I pull the carrier out and take off the ring gear, I am afraid im going to have major issues and need my rear setup again. By the way, Im running 4.88's.

For a 97+ Cherokee.

Need HPD30 carrier for 3:73 and numerically higher gears. Going to 4.88's Thanks, Justin

Ok, so I wrecked the 96 and I bought a 2000. The 2000 as you know has a Low pinion :mad: Well, the HP in my 96 is ruined so I cant use it. I am talking with a guy about one from another 96, but has abs. My 2000 has abs. I want to ditch so I can put my 44 in the rear. My question is, can I...

I have few engine mods done to my Jeep. The extent would be a K&N FIPK. I have done all kinds of suspension work to it and protection. So I decided to focus on the engine a little. Im not looking for an all out racing XJ. I recently purchased a 99+ intake and was wondering if a bored out...

D44 U-bolt style yoke. Used $15 plus shipping 1.75" Coils spacers Rubicon Express Brand new $25 plus shipping [email protected] Justin

All four brand new, never touched. Make reasonable offer. Can ship. Located in PA. [email protected] Justin

I just picked up a RCD60 froma 79 F350. I was wondering how the hub comes apart from the rotor. I took out all the internals of the hub and I have just the Hub and Rotor stuck together. I also knocked out the wheel studs. Any help is appreciated. Thanks, Justin:confused:

Re1600 Adj. track bar 5 months old- $80 Obo Re 2700 1.25" Shackles- $45 Obo Stock Driveshaft off of a 96 Classic with a 231 and 8.25 rear axle- $15 Obo...new ujoints. All prices plus shipping Thanks, Justin....Located in South Central PA [email protected]

All from an 89 Base model. Gauge cluster - 122,000 miles on speedometer Dana 30 - HP Vac disconnect 3.55 gears Dana 35 - 3.55 gears 4.0 Non HO - Supposedly ran before it became a donor vehicle, I would recommend rebuild Aw4 - Sold as is, I have never driven it before but it goes through all...

15x10 5on4.5 Backspacing doesnt matter. Need 4 of them. Looking to go cheap here, no bling. Located in PA Justin

Anyone know what the WMS - WMS is on a 78 bronco D44. I know where there is one and I was wondering how much wider it is than my D30. Plus how far off are the coils. I want to keep the radius arm setup. Is this axle more work than an EB 44? A lot of questions but I want to do this right...

I have the complete assembly ready to go into my Jeep. My question is, will I still be able to use the same slip yoke driveshaft off the old axle onto this one for the time being. I really cant afford the SYE right at this point, but my 8.25 is about to explode. TIA Justin 96 Classic(newer...

Does anyone know if there is a company that sells the internals of the 44 drums? TIA Justin

I am putting this up here for a friend. You can PM me for details. "jeep is an 1987 4-door xj. conidtion is fair (a number of trail dents a paint is fading a little). rear d44 is already spoken-for, but the rest is fair game. Command-trac t-case (130k miles, good condition) Auto-tranny (130k...

My girlfriends truck dropped a tranny the other day. I have no idea what it has in it. It is an aout that read P RNOverdriveD21 on the column. It is a 91' Ford F150 Lariat XLT with the 5.0. I know it has a Borg Warner T-case but I am not sure which one. I was going to go to the local u-pull...

I have a stange oil leaks that has been bothering me. Ther is oil coming from the back of the engine dropping down to the exhaust. Also it drips off of the front of the transmission. I have seen oil on the oil filter to. I checked the oil filter last time and made sure there wasnt an old...