Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I need the full dash and bezel. Ideally around Chico.
Or Access to one ideally not in daily use, in Chico. ( I need detailed measurements and ability to test fitment.)
I'm trying to combine the chassis harness from an 88 mj to the dash harness of an 89 cherokee.
I have an image of what I believe is the correct connector on the 88 but need to know the wires, can't find them specified in the diagrams.
I believe Orange is Pump hot, tan is fuel sender. No...
Fuel pump wires at kick panel, 89 xj
I need to identify the wires on this connector. Hopefully it's the one with the fuel pump
I'm connecting it to an 88 MJ harness that has a different color code and less wires.
So far I have
Brown right turn lights
Drkblue running lights
Really just need...
I need the wire colors for an 88 cherokee for the compressor and pressure switch.
I couldn't find them on the diagram
A non AC jeep would still have it in the harness right?
I'm thinking I might swap the entire 89 harness into the 88.
Edit: I think I have it
LT grn Black (from AC control)
To...
I'm taking the AC out of an 89 xj, putting it in my 88 MJ and converting it to R134.
What needs to be replaced? Just the drier and orings?
What doesn't have to be replaced but should be?
Thanks
87 4.6 renix stroker
Runs great at idle great above 2000. Only stumbles under load (uphill, quick accelleration)
Runs great with IAT disconnected (IAT reads correctly, tried a different one same thing)
TPS at 17% at idle. smooth increase all the way through throttle
MAP 27.5"HG engine off at...
Xj seats fit me really well but I'm interested in suspension for my back. who has done the swap? was it noticeable?
I'm leaning towards prp enduro but it's debatable. I'm not sure I really need reclining.
My front lower links are 46" long (3 link). This puts them at a horribly shitty position for everything. would shortening it to 36" make a noticeable difference? I have 14" coilovers I read on pirate that double your travel is fine.
bending isn't too much of a concern as they're way overkill...
My vents still leak after replacing them, not much but enough that in a roll over I may have issues. I plan on making a cover for the tank but a fuel pool wouldn't be much better.
Anyone else have this problem or a solution? I imagine some might and just don't know. I picked up some fuel...
I've been trying to find info on radios however most on pirate go into ham license land.
I just need some radios to communicate between spotter/driver.
Ideal would be 12v chargeable
mobile so we can swap between vehicles.
and Good vox.
What's the down side to using motorola FRS two ways...
Pulled my tcase to clock it since it's about flush with the frame rails and that was the best position on the clocking ring. I thought the ring moved but it's indexed there's only 1 way it goes on.
Their website says 0* is an option but this has to be atleast 10* off.
Blueline is Tcase up...
The 3 link setup I had made needs to be changed. The lower links are so far my turning radius is worse than an f250. I'd like to move the lower axle side in a couple inches and the frame side aswell.
Thanks for any help.
This is my current.
What's good, what's bad and would moving it in make...