Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Need a bit of help with over heating with the AC on. This is on my 97 w/ the 5.2L engine. It will run all day at 210*, even pulling a 2000 pound trailer. However, when I turn the AC on it starts to overheat. The water pump was replaced 4 or so years ago when I got it and I checked it at the...
I just found this product by DEI this evening. I figures some other people may be interested in it as well. might help with heat soak issues as well as cooling the fuel...
Coming home from work on Friday evening my XJ was rear ended. Some 20 yo girl that probably was too busy screwing with her cell phone. She used the hydroplaning excuse, however there was no standing water. Between the time I stopped and the time of impact there was sufficient room for her to...
I have taken apart a NV 242 transfer case to replace the bearings. I have a concern about the front output gear and the oil pump. The gear wear doesn't look that bad to me and unless someone says otherwise I will run it. However, the oil pump doesn't look great to me. Let me know about that...
Located in St Marys PA
One D30 Low pinion w/ 3.55 gears. No outer knuckles, no axle shafts. Just the housing with stock gears. 80,000 miles. $60/ obo. St Marys
One D35 w/3.55 gears. ABS Axles shafts included. No brakes. 90,000 miles $ 60/obo
Two D35 non-abs axle shafts. Some surface rust...
I need a new driver's window regulator for my 2000. Does anyone have experience with aftermarket units? I know Dorman makes one, but I try to stay from Dorman as much as possible. On ebay and amazon I see several different brands. One that looks interesting is the ACDelco 11A113...
Found this and thought I would pass it on. No relation to seller. http://www.ebay.com/itm/191476186773?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
Both my XJ and ZJ needed new tires. The 16" Icons from the XJ went on the ZJ w/ a set of Firestone Destination AT tires. A set 17" Dodge Charger wheels w/ Bridgestone Dueler Revo2s went on the XJ.
Last year the left front ball joints in my ZJ (I know, not an XJ, but it is a D30) needed to be replaced. So I ordered some Spicer units and installed them. 8000 miles later and the lower joint had play, more than the original ones I replaced. I talked to the supplier and was told to send the...
The headliner in the XJ was starting to come down in the back so I replaced it this weekend with charcoal 'suede' headliner. I borrowed the idea to use simulated suede material from urban yan http://www.naxja.org/forum/showthread.php?t=1064814. I used two and a little bit of a third can of 3M...
I'm looking for a worn out stock steering pump for my 2000. The case and shaft have to be intact and the pulley would help as well. I don't care if it pumps fluid or not.
I'm looking for a worn out stock steering pump for my 2000. The case and shaft have to be intact and the pulley would help as well. I don't care if it pumps fluid or not.
Doug Thorley offers a very nice header. However, their support is complete and utter crap.
Previously I had problems with their header. First the original one I purchased years ago cracked. Keep in mind it had a life time warranty. The problem was identified and they redesigned their header...
This is sometime I have been wanting to do for a while, install an oil cooler/heater. For two reasons. 1) It takes much longer than I would like to get the oil up to operating temp, much longer than the coolant. I don't have an over heating issue with the oil though, so its more for the heater...