• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by Zel94XJ

  1. Z

    Several Problems 1 solution?

    I threw my Vac gauge on the engine and had a solid 19" of vac. So i'm not thinking its a Vac leak at all. Must be a electrical issue.
  2. Z

    Help with water pump install... how do I stop the pulley from spinning?

    I got the fitting from Home Depot. I don't remember the size but I got the idea from this forum. I think the barb size was 1/2" or 3/4" but don't hold me to it. Just don't forget to seal the threads with thread sealant. I suggest using the stuff in the tube verses pipe tape. You can get the tube...
  3. Z

    Help with water pump install... how do I stop the pulley from spinning?

    I replaced that pipe with a hose barb fitting when i replace the pump. Mine was almost rusted through in several spots.
  4. Z

    Several Problems 1 solution?

    Well after beating around the bush, trouble shooting my transmission issues from every available angle I had to bite the bullet. I traced the transmission wiring from TCU back to the transmission and discovered it was all perfect. That left only one possible issue. Replace the shift solenoids...
  5. Z

    Several Problems 1 solution?

    Idle's at 900-1000 all the time {warm, cold, etc.}
  6. Z

    Several Problems 1 solution?

    Here's the setup: 1996 Cherokee Country 2WD - AW4 4.0L Symptoms: Idle: 1000 rpm Throttle position sensor range: 0.84 - 3.89 {5.01v input v+} Shift issues: Have to manual shift aw4 to drive Battery Voltage at TCU connector No resistance on shift solenoids 1 & 2 spec {11 ohm} on the TC...
  7. Z

    Jeep shifting problem (ITS BAD)

    *BUMP* For updates
  8. Z

    ac electrical problem, no power to compressor

    O.P. Did you resolve the issue?
  9. Z

    Need A/C Advice please

    I was back probing the the electrical connector and noticed that when the Compressor clutch quits the V+ drops to 0. I am now thinking it maybe one of the pressure switches. Where are the high and low pressure switches? There is one on the evap canister newar the alternator. Where is the other...
  10. Z

    A/C back in action!

    Was there something wrong with your A/C? IF so please share the problem and solutions.
  11. Z

    Need A/C Advice please

    I went to junk yard and pulled the compressor front plate from a 95 XJ. I pulled my magnetic plate and it was corroded on the back. I cleaned the new plate from the yard and installed it with only 1 shim and the air gap seemed perfect according to sandens pdf manual. there was no change. 5...
  12. Z

    Need A/C Advice please

    *update* After allowing the engine to cool an hour i get the same result. Compressor on for 5 minutes then nothing.
  13. Z

    Need A/C Advice please

    Ok here's the situation: My Cherokee (1996 4.0L, 4x2, AW4 Auto, 138k) At one point earlier this year my A/C worked ok but not great. One day i flicked the A/C on heard the click or the compressor coming on then after 5 minutes the compressor clicked off not to turn on again for the entire...
  14. Z

    Vegas Trip Questions

    If the goal is getting trashed in vegas then yes the slushies will wreck you well enough and they are not too bad in the price. Getting drinks is not hard in Vegas you only need to play some games and a server will be by to ask what type of drink you want for free. The catch is you have to sit...
  15. Z

    Vegas Trip Questions

    I 2nd the idea of going to downtown Vegas. More character and cheaper drinks than buying at the bars on the strip. I just got back a few months ago and it was cheap. Stayed at the Luxor. It was full of young people and the pool was packed with hotties. It's cheap and the younger crowd fills the...
Back
Top