• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by yetimotronic

  1. Y

    Head Noise (video)

    Was the motor hot or cold when the video was taken? I didnt see the temp gauge in the video. Not to be an ass but are you sure that noise is from the valve train? you didn't say anything about diagnosing the noise. Using a stethescope or a tubeof some kind to hear through. Sounds alot like...
  2. Y

    Piston slap questions

    piston slap goes away when the motor is revved up regardless of a hot or cold engine. ie if you were to hold the the throttle slightly open after start up and not hear a knocking noise, but hear that same noise at idle that would be one way to confirm piston slap.
  3. Y

    Extreme metal music

    kings of sorrow are pretty sweet. jamy jasta (from hatebreed) side project. surprised refused and dilinger escape plan havent been mentioned.
  4. Y

    oil pump replacement?

    98 4.0 167xxx auto. my rear main is def in need of replacement. my oil pressure is good, nothing odd going on at all. 40 psi at speed and around 18-22 psi at idle. this was verified with a gauge with the car at operating temp. i dont have oil pressure issues, but ive read a ton of threads about...
  5. Y

    97 cherokee TCU swap

    i ran a 97 tcu in my 98 for about a year and had zero issues. i was operating under the impression that the 98+ have different sensor arrangements than a 97. i didnt feel the swap would work because of the sensor arrangement, but low and behold about a year went by with zero issues.
  6. Y

    Tranny code question...

    i have a 98 xj as well and battled these codes for some time. i had very similar problems\symptoms. it took me a few tries to get the nss adjusted for things to operate correctly. despite using a continuity tester, i still had to have another set of eyes on the reverse lights to make sure they...
  7. Y

    not a death wobble question but a steering question

    search around for the zj v8 tie rod upgrade. it is rediculously simple to do and the cost is minimal as well. i recently did this upgrade and have been very satisfied so far.
  8. Y

    A/C Question?

    x2 on the gauges according to my 98 factory service manual, if the compressor cycles 10 or more times in 1 min than the refrigerant is low for one reason or another.
  9. Y

    Motor flushing

    the cooling system is at 15lbs of pressure and city water pressure is some where in the neighborhood of 20 to 25? not exactly sure maybe more. don't go full throttle with the garden hose when flushing the heater core as you might damage it. dont ask me how i know.:doh:
  10. Y

    Midwest Craig's list Thread

    detroit.craigslist.org/mcb/cto/1841589700.html
  11. Y

    Need a Rubicon Express Product

    RE 6025 chryco 8.25 np231 shipped to 48236. thanks
  12. Y

    Midwest Craig's list Thread

    URL="http://detroit.craigslist.org/okl/cto/1780489647.html"] idk:dunno: seems ok
  13. Y

    does anyone have anything good to say about the RR steering?

    the rr setup is garbage. i ran this setup for 3 years. could not hold an alignment, had the biggest dead spot and the tre's would constantly wear out. for 75 bucks you could do the zj steering upgrade, which is what i just did, and be way happier. no dead spot, alignment is spot on and getting...
  14. Y

    Midwest Craig's list Thread

    sounds almost too good to be true http://detroit.craigslist.org/wyn/cto/1599444349.html
  15. Y

    Oil filter adapter Early 4.0HO

    i had a 93 and i had the exact same issue with the oil filter adapter. just shaved the hex key down a bit until it fit the oil filter adapter bolt. i don't recall what size the hex was off hand though.
See more
Back
Top