Recent content by xjennyj

The 4.0 engine in my 2000 wj died but I found a 4.0 engine from a 2001 xj. Will there be huge issues with this swap?

I recently purchased an information center from a 93 zj limited and attempted to replace the standard one in my 93 zj laredo. I noticed that there are two wiring harness plug holes on the limited information center that I purchased, while I only was able to locate one in my vehicle. Could this...

Does anyone know where I can get some good regear instructions on the web for a first time regear-er?

Checked all of the sensors...nada. I don't feel all that bad, though, since we can rule those out. Got a new O2 sensor, too, while we were at it. We are thinking fuel pump for sure. But I have a question. We disconnected the fuel line to see if it was pumping gas when he turned the key...

Thanks for the replies...keep em coming.....This is a ZJ, not an xj, I think thats what you meant, though.... Ok, yesterday. Reconnected O2 sensor, and replaced idle control sensor, ran great for about 10 minutes, then started the same old, same old-but this time, only around corners. This...

It has 215K. The air filter is fine, probably should check the fuel filter. Assumed the sensors are all fine, at least they were throwing the appropriate ohms and/or volts, whatever the Haynes specifications were. Did a fuel line and pressure test..I think it was 30 instead of like 31 (or...

Having problems with a 5 spd, 4.0L ZJ-GC. It started having problems with maintaining power going up hill- to having problems at any time under load. Also, recently added to that list, it is hard to start, and when it does, (from a completely cold state) the rpms jump up to around 2500 or so...

Thanks for the help!

I want to put 4.10 or 4.11 gears in my xj dana 30/35 combo. If I am only swapping in the ring and pinion from the yj (I will get master rebuild kits as well, but I will get those new), which years will work on my xj? I am getting mixed opinions as far as spider side gears and abs go, and...

bump, would really like to get a set...

I am very interested...sent pm

I would like to find 4.10 or 4.11 gears for an 89 xj dana 30&35 combo. I will also need a carrier for the front in order for me to run the 4.11s. Thanks.

My driver's side coil spring bucket is pretty rusted out, and I need another one. I found a stock tj bucket that I can get for free, but I am not sure if it will work or not...Does anyone know?

I pm'd you about those control arms...what is the length of them?

You should also consider the size and width of each tire. That will definitely make a difference. I take my 33x12.5's mud terrains off in the winter in favor of snow tires because, in my opinion, I often felt unsafe on those icy days. Like you said, though, in the deep snow (and just snow)...