Recent content by XJ jay

Double post.

Its my experience that "temporary" usually becomes permanent. Butt connecters are a step above wire nuts and still in the realm of butcher. I have extensive knowledge on 12volt wiring as well as proper install techniques which does include trailer wiring and LED lighting. Wiring issues...

Wire nuts. Your a hack

http://www.gearinstalls.com

Sounds crazy but i also look at the pattern on the drive side of the pinion. Its shows subtle changes better. If it runs close to the root on the pinion shes shallow on the ring. If it runs close to the face or the outer edge on the pinion shes too deep on the ring

Are you jamming a rag between the ring gear and housing and turning the pinion or a rag wrapped around the pinion yoke and housing and turning the ring gear with a box wrench on a ring gear Shes looking deep on the drive side.

Spool!

bump

Not a huge need to regear with 31s I went Sliders Lockers Longarms 33s Gears

Moab Brewery was alright, the Blu Pig was better. We heard great things about Pasta Jays as well, i intend to eat there next time im in town.

I dont recall grinding down my 4.56s to get the cross shaft in, but it was a year ago, anyway, looking forward to seeing what the outcome is.

4.56s

Well done

It went snap all right.

You should see the pinion on a set of 5.13s for a JK 30, the bearing inner race is almost bigger then the pinion.