Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I installed a agate colored interior into my 98 and need to swap the lock cylinder from the mist gray to it. There is a hole located toward the bottom of the lock cylinder through the plastic. Not sure if that has anything to do with removal. I tried and couldn’t. My other option is to use the...
Ya I think NAPA hoses are also Gates. And the metal heater hose tube is a repackaged Dorman. I have a NAPA less than half a mile from me. Been using their parts for 25 years without any issues so I stick with them. Just sucks when I can get the same stuff cheaper from Amazon and I even get a...
Did you also pull the rear driveshaft out and grease the heck out of the splines on the slip yoke? Worth a shot and if it doesn't fix it I'm sure it's likely needed anyhow.
I had two factory originals go out so far. One at 163,000 and one at 215,000. Still running one at 211,000. Not sure what would cause such short life. I would assume belt tension but if you're on top of that then i don't know. Have you done a flush? Do you use distilled water? Also when they go...
Cables loose or dirty or old corroded brittle and fraying? Grounds to block and fender? What shape are they in? Battery to PDC and alternator to PDC are crucial for charging for sure. I've had issues with cables on two 98's and the 01 I have is fine for now. One 98 I got away with just putting...
The double cardan joint on the front driveshaft will chirp and grind when the ball/socket get dried out and worn. Really bad on cooler to cold days. When it's warm they won't make a sound.
So I have searched and also asked on other forums. No clear answer. One of the Cherokee's I bought had about 6inch lift with RC adjustable tracbar and drop bracket. Also has a drop pitman. The angles are way off from one another. It's odd because I also have one I purchased to use for parts with...
There's a lot of decent looking ones on Amazon. When I do mine I plan on using a relay box with a cover. I've also been contemplating using a harness for 4 headlights. I'll run 2 relays from each side of the factory harness. One set will operate the headlights and the other set I will wire just...
I was actually thinking about buying the Rusty's cut corners. Similar product but they're $50. Then there is a second piece which is sold separately for over the fuel filler hose. Might just make my own though. The PO really jacked up the cut and fold. I was thinking of cutting off some rear...