• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by transam89gta

  1. T

    possible rod bearing issue

    its not a knock its a tap and once i get it driving and oil pressure up it stops oil pressure is at 10 idling and a little over 20 while driveing at 3000 rpms
  2. T

    possible rod bearing issue

    ok jeep has been parked, but cranked and maintained for around a year and a half. got it registered again and drove for a week running good still looses a little water because of the freeze plug in the head leaking. ok never ran hot had new oil and a good filter not fram cranked it today and...
  3. T

    Axles, T-Case, Ax-15, Borla Header

    borla header shipped to 71112?
  4. T

    Freebie: ORO 2nd gen U turn steering linkage

    i'll take it if anything falls through
  5. T

    Lots of XJ stuff for sale

    the 30 brace shipped to 71112? send me a pm
  6. T

    RockKrawler XJ Long Arm UPgrade @ DesertFab

    shipped to 71112? thanks
  7. T

    rusty's engine skid

    pm'd
  8. T

    ZJ rear disc brake conversion

    did mine 27 spline 8.25 stock PV will lock all 4 up on 32's was a slow stop with drums
  9. T

    LOL remember the land rovers at superlift?

    yall just don't know!! he's just showing those spinners off LMFAO
  10. T

    New car ~$30k need reccomendations

    yea i know that just giving my input. others have posted why pick on me
  11. T

    Jeep 2500 Parts... I found them here...

    ok love it screw u haters
  12. T

    New car ~$30k need reccomendations

    my wife had her rx-8 at 110000 miles no issue manual loved driving it does burn a bit of oil but less than my xj have a project xj i'm swapping the rx-8 motor to since my wife got wrecked out insurance buyback
  13. T

    fuel tank skid?

    did that but someone welded my rear hitch on any advice? sorry to hijack but this has me don't want to cut the unibody and they did a good job on the welding
Back
Top