Recent content by TINY XJ 6

Any one know how long a stock driveshaft is on a 2000 XJ with an auto, NV231, and a D35? And will it fit on a 94 XJ with auto, NV231, and corp 8.25 rear?

Here is a picture of the mounted high lift "http://i239.photobucket.com/albums/ff172/ocarr95/Picture022.jpg" I used four 1/4" alligator type wall hangers, washers and nuts. I then drilled holes in the seat frame and mounted the hangers. I then used fender washers and wing nuts to hang the jack...

I'd love to post a picture but cant figure out how to do it.:helpme:

I'd say go with the 2 nuts with pb. It worked for me.

Has anyone else ever mounted a Hi-lift jack to the back side of the rear seat? I just finished mounting my 48" jack, and it fit great.

When I put a 8.8 in place of the D-35 I went from drum to disk brakes. It kept feeling like I had to bleed them. The proportioning valve on your XJ is set up for drums. I replaced mine with a proportioning valve for a 03 Rubi(same part as the ZJ) witch has a disk/disk set up front and rear. Now...

I also used the orange with no problems.

I had a similar experiance with mine. It looked like it was coming from the housing, but it ended up coming from the speedo sensor. It turns out it wasn't seating properly, and had damaged the O-ring. :banghead:

I put Herculliner on my winch bumper, rockrails and, fender flares. It has held up well with trees and dirt but rocks will scrape it off. I took my time on the prep work and I'v had good luck so far in the winters.

00-05 Dodge neons had comp ,temp, and maplights.