• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by the_shotty

  1. T

    Renix issues

    I just did the dipstick grounds for a second time, I did all of your ground upgrades last winter. Before changing out the negative battery cable this go around I was getting .02 resistance between all the ground locations and my negative battery terminal. I have not compared since changing the...
  2. T

    Renix issues

    Ok I finally have everything back together, I changed all the radiator hoses, coolant, got rid of all the AC lines and junk other than the compressor which I will eventually use for OBA. Other than that I went and re did sensor ground at the dip stick, installed a new negative battery cable...
  3. T

    Renix issues

    I have done this twice cruiser if you are referring to me.
  4. T

    Renix issues

    I'm still working through stuff. I pulled the dipstick grounds and cleaned them as well as re greased them even though nothing appeared out of whack and had good resistance between them and negative battery post. I do have a brake in the output wire in the harness for the o2 relay harness but I...
  5. T

    Renix issues

    Ok so tonight I verified the ground wire from the 02 heater relay to the ecu was good and fully pulled out the ecu. Holy cow I forgot how much of a pain that was! It was a little crusty under there and there was a bit of rust on the mounting bolts. I tried cleaning that up, I have already done...
  6. T

    Renix issues

    I'll try and sort the o2 sensor out and see if that fixes it. I think I'm going to do an AC system delete while I have everything torn apart so it may take me a little while to get it all sorted out.
  7. T

    Renix issues

    I pulled apart and soldered all those grounds in the harness. I have the harnes all pulled apart again right now as I am not getting the 12-14 volts on the orange wire to the O2 sensor and found a brake in the wire at the relay plug and also have no ground at the plug. My TPS ground shows .02...
  8. T

    Renix issues

    So, on the map sensor, I have 5.04 volts motor off/ ignition on and when I turn the motor on I get 2.04-1.92 when cold and 1.82-1.75 warm .2 resistance sensor ground to battery.
  9. T

    Renix issues

    Hey guys, I've never been one to post but I'm not sure where to go from here. I've read pretty much everything I can find gone though posts from 5-90, cruiser, and echomike remix issues and have attempted to address all the issues they have come up with. I have a 90 Cherokee 4.0 auto with an 92...
Back
Top