Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I just recieved mine in the mail today. Just got done spray painting them. I'll see how the install goes tomorrow with the engine in the rig. Apparently I'm the '95 year guinea pig.
I'm surprised noone has mentioned this yet. With the top up on a half door TJ, visibility sucks. Huge blind spots to the sides, both to the back and to the front.
I tried that today. Appentrently I slipped or something and welded a blob somewhere on the side above the bolt. I get to a certain point when I'm screwing it out and can't seem to move it anymore. Weird thing is I don't see anything in the way. I'm pissed with it right now. Shouldn't have...
I have that code still coming at me even though I replaced the TPS too. I'm sure it's a wiring problem. Mine dosn't rev high though, it stumbles when I accelerate. Happens when ever it rains/has rained. Hasn't happen in the past few weeks though since we've been in a drought. It's the least of...
Ok, so I installed the PORC SYE, and everything seemed pretty good install wise, besides the fact that I didn't use enough permatex on the bottom of the housing,so I have a slight oil leak. I'm running it in 4H without a rear driveshaft (aka, badass FWD jeep), but it likes to pop out of 4H and...
I run 4.5 inches in the front. I use the RE Drop brackets with the stock CA's. Works great, rides better then when I was at 2 inches. At 4.5 inches, you'll need either the drop brackets or longarms to have a good daily driver. Plain Adj control arms just won't cut it.
Search "death wooble". You'll find lots of info on it. You'll know if you have death wooble or not. I just have a shimmy most of the time, but the first time I had death wooble, I was about to shit my pants. You literaly think your front axle is just going to fall off.
I got it. Ended up using the viesgrips as tight as the would go, and used a ratchet with a ujoint to get the weird anlge that the nut is on. After I got the nut off, I hammered on a 3/8 socket, and drove it out of the case. Now my problem is that my snap-ring pliers are a POS, gonna go swap...