Recent content by SouSy

I can't remember if they came with an ax-4, I know my mj has one though. This particular 85 has an ax-5 but it's going to hit the scrap pile. If I remember right the nose itself isn't shorter, the radiator support is definitely different. Radiator support needs to be changed because the 2.5...

I'd really like to keep it a five speed truck but I don't have any sitting around. I wouldn't mind trying out the AW4, I've got a few of them sitting around so no worries if I mangle a couple. I've got a built 4l60 that I can't give away, probably wouldn't last long. If I come across a 4L80 for...

What is your volt gauge doing when the pump starts to get loud? Load test the power and ground at the fuel pump connector. Grab a turn signal bulb (preferably with a socket and pigtail so you don't have to get too creative with wires,) hook it up to the power and ground at the fuel pump...

I know, I can already hear you furiously typing about how this is a pointless project and to just find a Cherokee that already has 4.0, but hear me out. We have an 85 sitting around with a 2.5 and we've been on the fence for almost two decades on what to really do with it. I'm finishing up a...

Yeah, i'm not a total stranger to the jeep world. I've had a couple lifted yjs. My opinion is that I am one of those unique xjs that need a sye at 3 inches. I put the jeep up on a two post lift and discoed the trac bar then adjusted the new trac bar. Seems to be centered, we'll find out after...

The pinion level with the t-case would make a hell of a vibration. He ment that the angle of the u joint at the pinion should be the same as the angle at the tcase

I thought the 96+ np231 almost always needed a sye. Something about the change in the tcase tailshaft

I agree, it is also completely irreverent as the springs are already shimed. Thats not his fault though, I should of mentioned that in my first post. So anyone know whats up with using the front shaft for the rear after the hack and tap? I hear mostly that it will work fine, but quite a few...

First off 97 xj 3 inch lift full leaves installed. I had some vibes after the I got done so I installed a inch TC drop. I still have a vibes on accel between 25mph and 40mph. Will I be ok to drive like this for a while until the hack and tap gets here and I get time to install it? Also will a...

I've been thinking of selling mine, only because my buddy bought a new duramax and I have no one to ride with. It's an 04 ninja 636 I just checked the gauges, 3,517 miles. It needs a fork seal and an exhaust (that one is a long story) I have the title, and i'm wanting about $4000 if I sell it. I...

Trade for a 04 ninja 636? Call chase at 712 326 9870

Radio? Does it have the rear sound bar?

bump

I'm starting a full width chevy 307 swap and need some extra cash so I'm selling off all my extra 2.5 parts. Its a 1985 Jeep Cherokee 2.5L 5 Speed. 2.5 is blown, the two screws that hold the air cleaner bolt in backed out and fell into the carb. Basically everything is for sale except for the...

Hey man, can you shoot me some pics. [email protected] I'm in Council bluffs.