Recent content by SolarBell

When mine had the same issue it was a bad engine block ground.

The Colorado BS thread Well, consider this an open invitation. I just need a few days notice and a picture or two to make sure I have the right pieces for setup.

The Colorado BS thread I’m waiting for someone to want to shave a 14B since I’m pretty certain my “new” milling machine could make short work of it.

More free stuff. I have a set of towing mirrors that strap onto smaller mirrors when towing trailers wider than the vehicle. Frames are dirty but the mirrors are in great shape. Fits the XJ but lots of others too.

Depending on the price, I might be interested in just the D30. I want the WJ setup, but I can part out the rest.

Bump. Sill have the knuckles, transfer case parts, and the 29-spline 8.25 axle shaft.

I’ll take it.

Re: The Colorado BS thread Depends on your level of bandwagon...

You bet. Since you have something for me we should work out a meetup at some point.

Looking to finish accumulating parts for a WJ knuckle swap. Just checking to see if anyone has any of the bits I need on a shelf gathering dust. - Upper ball joints - Brake rotors (I'll take used so long as they are in spec) - TRE's Thanks.

More stuff. Leaf spring angle wedges, 2.5* 2-piece XJ knuckles, I think I may have 2 sets of them.

I found some stuff sitting around that I don't want to store anymore. Free to anyone who wants them. New bearings for a 232 transfer case, partial set (I'm getting a list of exact bearing numbers) Used but in good condition chain from a 242 transfer case Head gasket and valve seals...

Just a random inquiry, I'm looking to see if anyone has any 1/16" or 1/8" thickness neoprene or buta-n rubber sheeting (or even a piece of treadmill belt) sitting around they would be willing to part with for trade / cheap / free. Looking for 2 pieces about 12" wide and 24" / 36" long. PM or...

Didn't coat the threads. It was the face of the thread insert that the jam nut was tightened against. The powder coat was smooth enough that the jam nut was working loose with just a little vibration, even though it was very tight.

Note for later - powder coating and jam nuts do not play well together.