Recent content by richamor

I think I'd have a look inside the rear diff. Maybe a bad pinion bearing, carrier bearings, excessive backlash in ring/pinion. But....as mentioned checking that drive shaft for balance is a good place to start and work your way back. The trans would be my last stop. If it were the problem I...

This is a great idea! Thanks!! "A little trick for increasing the output of your CPS is to drill out the upper mounting hole to 3/8″ from the stock 5/16″, or slot it so the CPS bracket rests on the bell housing when pushed down. Then, when mounting it, hold the CPS down as close to the flywheel...

what is the WP? water pump What kind of transmission do you have in there? AW4 automatic

Figured I'd get the new UCA bushings in while the motor was out.

Be prepared for a fight. The top bolt on the passenger side is a beyotch. I took the motor mounts off and dropped the motor enough to get to it from the top. And since that was all that was holding it at that point the motor came out without a problem. Label everything. I put all of the bolts...

1989 XJ. So the motor is out for rebuild. Will be replacing the rad, WP, mounts, thermostat and housing converting to open cooling system. Will be checking and replacing all hoses that look bad. Have a Mopar CPS to go in. Probably replace the knock sensor as well. The jeep ran great until the...