Recent content by revmaynard

Hit a sad milestone Thursday and threw a fun sticker on to support some buddies!

Hey guys, I'm looking for a set of manual front doors from a 4 door XJ with panels. Ideally located in or near Georgia. Thanks!

I am pretty certain those are export taillights on all of them.

They've done great for me so far, granted I rarely drive my truck. My coworker daily drives his TJ on the 35" versions though without any complaint. Thanks man!

Thanks! Thanks man! I have attempted to go somewhat period correct with the look! I love them. They will sing to you on the highway, but they've been a great tire with great wear so far! They are basically relabels of the Maxxis Big Horn.

Finally getting around to uploading some images of my finished JCR rear bumper.

Yep

I won MJ ride of the month on the Comanche Club forum. Here are the photos I sent over for it.

The clutch is still a little wonky after replacing the leaky internal slave. Double and triple clutching it works most of the time. I've currently got my AX15 being rebuilt so that will just go in instead of dropping the POS BA10 again to fix it. I got a JCR rear bumper kit that is a DIY. My...

It's basically a 91-01 kit. I slid the tube into the rubber accordion piece, trimmed the heat shield to clear the hose and there you go.

I got my winch mounted in the bumper and installed some cube LEDs on the stinger. I haven't wired any of it up just yet because my battery doesn't have enough CCA for the winch so I figure I'll wait and get a new one first. I had to recently replace the CPS, coil (again), and rotor (again)...

Nah, nothing embarrassing. Swapped the new CPS for another new one and started getting a reading there, still no spark so I replaced the coil because the new one was a cheap Chinese one and everything appeared fine up until the coil. After that I got spark testing with an inline tester. So after...

Solved.

Hey guys, my MJ decided not to start this morning randomly and is getting no spark. The truck has had less than 3k miles put on it since I did a new coil, plugs, wires, cap, rotor, load of fuses, etc. I decided to check my CPS first and noticed it had been chewed up a bit (the truck sat for...

It's the old one from my Cherokee stump and I built.