Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
A lot of folks will say how bad the body lean is, but damn, you are driving a lifted shoe box for god sakes! If you want to take corners at high speeds, you might want to find another hobby...
I am trying to get a reference on stock ride height. I have searched, but the only standard measurement anyone has posted are from center of wheel (hub) to bottom of fender flare. My XJ has been cut on a bit and has no flares. I was wondering if anyone could give me the stock ride length of the...
Just got back from Uwharrie, NC and thought you all would get a kick out of this...
http://s244.photobucket.com/albums/gg17/rcmf5525/?action=view¤t=VIDEO_009.flv
does anyone have a copy of the installation instructions they could scan and send to me? Im not the sharpest knife in the kitchen when it comes to electrical stuff and dont want to screw up anything....
Thanks...
Where in the heck do you order complete Chromo shafts? I have searched my ass off and can only find the outer stubs and custom length. I consider myself to be a searching master when it comes to Google, and I am stumped...
While searching, I found this unique fabrication: (move your cursor over...
2.5" might have been a little inflated, but it was too far forward for sure. I have it set up a lot better now. Just FYI, the uppers that they said are redesigned, are smaller than OEM. The RK kit I just recieved replaces the upper bushing with one of their joints, but I could not use it due to...
My DS fit, but did not have much compression left. I guess I will take about an inch out. I put a 60 under the rear and the DS could stand to be almost 2" shorter...
I talked with the local drive train shop about shortining the sticks and they quoted me $75 to shorten and $75 to balance. How...
I just put one of these TnT trusses on a 44 and installed it. I am having some issues with the upper control arm brackets and the coil seats having more stand off than stock. I think the coil seat is farther forward of the axle centerline than the D30's. I could not get the coil seat to line up...