• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by Quailman

  1. Q

    Misfire after injector upgrade

    Damn really? That’s disappointing I thought they had good ones lol
  2. Q

    Misfire after injector upgrade

    If I had to do it all over again, I would spend the extra money and get them from ksuspensionfab.com Seems like the best way to go to ensure you’re not receiving junk. They offer new or refurbs (refurbs are probably perfectly fine), and you just enter your year range, they’ll send you the right...
  3. Q

    Misfire after injector upgrade

    I’ll keep that in mind, thanks! I bought the headlight harness upgrade from him a while back, didn’t realize he did injectors too.
  4. Q

    Misfire after injector upgrade

    Really just because the ev6 seems to be the majority of what’s out there. From what I can tell, the Bosch 703’s from the dodge neon which were the “go-to” part number for this upgrade are few and far between these days. I had a hard time finding them. Or maybe I just didn’t look hard enough lol...
  5. Q

    Misfire after injector upgrade

    Thought I would share my solution for anyone with a similar issue. I swapped in the 2 replacement injectors the seller sent me, and right away had a check engine code for injector #4. After wiggling the connectors, the misfire went away (hadn’t observed this before). I’ve determined the...
  6. Q

    Misfire after injector upgrade

    Tested the resistance on the injectors. Sitting around 12.5 ohms “cold” and 14.0 ohms “hot”, seems normal. Now, it seems to be happening more frequently. And get this, the last couple times, it’s thrown codes for misfire on all 6 cylinders! P0206 for circuit failure on injector 6, plus...
  7. Q

    Misfire after injector upgrade

    So I tested the injectors, all are reading around 12.5 ohms "cold", and 14.0 ohms "hot". Seems normal.. I guess I'll see if swapping the two new ones in helps. If not, I guess it will be time to buy a new set from a reputable seller.. Thanks!
  8. Q

    Misfire after injector upgrade

    Haha fair enough! I gave it a shot this morning, didn't seem to make any difference. I'm at work now and have both the positive and negative disconnected. When I leave, I'll go through the reset procedure again to see if it helps. Good news though.. I heard back from the Ebay seller. He said...
  9. Q

    Misfire after injector upgrade

    I disconnected the battery plenty of times but didn’t go through the legit reset procedure. Most people say you shouldn’t have to.. I’ll try that though!
  10. Q

    Misfire after injector upgrade

    So the resistance would be out of spec 100% of the time even though the problem is intermittent? That’s good to know, that’s what I was worried about. I have a multimeter at work so I’ll check all 6 first thing in the morning. I reached out to the seller but who knows if I’ll get a response. Thanks!
  11. Q

    Misfire after injector upgrade

    Also.. any advice on how to electrical test the injectors if the issue is intermittent?
  12. Q

    Misfire after injector upgrade

    Are failures for junky eBay injectors common? The guy I got em from had super good reviews but hey stuff happens right? I guess $55 for a set should’ve set off my “too good to be true” radar.. My first thought was that I chooched the connector on the harness, but that was when I was only getting...
  13. Q

    Misfire after injector upgrade

    Hi all, I recently did the 4-hole fuel injector upgrade on my 96 XJ with some eBay Bosch refurbished injectors. Ran fine (great) for 2-3 days, then I started getting intermittent p0202 and p0302 codes for injector circuit failure on injector #2. It would misfire and run really rough, but then...
  14. Q

    96 XJ HVAC only through defrost vents

    Update: I recharged the system and the e-fan works now. Turns out it IS connected to the failsafe that prevents the compressor from turning on if the system is too low. Now my only problem is the vents still. To answer your question, all 4 fan speeds work fine, definitely not the blower...
  15. Q

    96 XJ HVAC only through defrost vents

    I will check this ASAP, thank you for the advice. I've also noticed that when the face vents do decide to work, ALL vents blow for about 10 seconds as if the blend doors are opening and closing, but just VERY slowly.. The A/C definitely needs to be recharged due to a leak (separate issue). I...
Back
Top