Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Extended lower control arms, 16inch eye to eye. and a stock rear drive shaft. Anyone want these too before I throw them out?
Eric,
located in long beach
Does anyone want a set of drums and pads. This came from my xj with a c8.25 rear end. They are practically new and the drums have been painted. I recently converted to discs in the rear and don't need these anymore. You can have all the new hardware too. I need to get rid of it and don't want to...
Rusty's 3 Inch Coil/Add-A-Leaf Lift Kit used for $100
Included:
Front Coils
Front Shocks
Rear Add-A-Leafs
U-Bolts
Rear Shocks Missing...
Eric,
Located in Long Beach, Ca
PM me for contact info
Hi, this is a used Aussie Locker for a D30 27spline for $100. It came from my XJ and I was the original owner. I had snapped the front right axle and then did a full rebuild and upgrade of my D30. I don't have a use for this locker anymore and figure someone else can get some usage out of it at...
Hi, like the title says
98 XJ Rear Drums, Shoes, Backing Plates, Cables, New drum spring parts. These were all new and installed for like 100 miles before I pulled them off. The backing plates and cables are original. $40
Its been a while since I put it together, but I never ground any teeth. So I probably installed the locker then torqued down the ring gear.
I was looking at grinding teeth, but they would have to be ground quite a bit to get the shaft out. I was never comfortable grinding away teeth.
I don't see any way that I can get the cross shaft out. it's the larger carrier with 4.56 gears and the ring gear is in the way of the cross shaft sliding out.
Hey, I was hoping you guys could help with some tricks. I have a broken axle piece on the driver side stuck in the d30 carrier with an Aussie locker. I can't remove the carrier cause the broken piece is just a little too long. I can't remove the Aussie cause the ring gear won't let me push out...
Hi everyone,
I was wondering if anyone knew of a relatively cheap reupholster shop that could do my 98xj driver seat? it's that bluish leather and is torn in like 5 spots. I figured I could get it redone for probably less than a high quality neoprene wet okle seat covers =)
Thanks,
Eric