Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
The stance today
Still a lot of work to do, but at least it's driveable now.. They ride pretty well, took a few extra weights to balance them out, but they're great tires.
I do have to give the dana 30 credit where credit is due.
But in no way would it stand a chance of holding up with 39's
I'm glad I have the non disco front with the 1 piece shaft.
But if I can source a nice wagoneer 44, i'm definitely gonna snatch it up for peace of mind.
Yeah that's a smoking deal
I have a set of Cooper Discoverer SST's 33x12.50r15's on hold from a friend for 250 with ~ 60% tread, and they run like 299 or something each new.
Then I can get these ridiculous Baja Belteds off of it and hopefully sell them to somebody for 200 bucks or so.
They'd...
Re: Tom95YJ's Faimly Wheeler Build ...
Real nice rig, sorry about the fender bender, but it sounds like it's gonna work out in your favor and pay for a few new parts! :P
I really like that bumper, I might have to look into one of those.
Thanks bud, it was a hard loss definitely, but he was suffering from many ailments and was in a lot of pain.
I also have a 95 Orvis ZJ that was daily driver, I had some plans of building it out, but i'd rather build on the XJ platform.
Here's a couple pics from where I left off (4.5"...
I sold my XJ 3 years ago to my Uncle, who needed something to drive on short notice and didn't have a ton to spend at the time.
89' Laredo
4.0
AW4
NP231 With a AA SYE. (came factory with a np242)
87' D44 Rear
D30 non disconnect front.
About a month ago he passed away, and he had been telling...
4wd tranny w/ transfer case. (I'd also grab the crossmember, as I can't recall if they're different.)
Front Axle (non disco will be easiest)
Front Driveline
Cut hole in floor for shifter.
Drive.
An SYE isn't really needed until about 4-4.5 inches of lift.
They make bolt on track bar relocation brackets, that center your axle, if you're looking to go cheap.
3-3.5 inch kit's are fairly cheap.
2'' lift is dirt cheap, but you're not going to run a 31'' tire without some cutting.
It's up...