Recent content by nates94xj

I submerged my winch for bit awhile back, so I decided to take it apart, check for corrosion and regrease. After reassembly it spools a little slower and after a about ten seconds of line in it just stops working for awhile. I noticed that the spool right around the brake feels really hot...

Crikey, you guys have some serious post counts! Thanks for sharing the wisdom! I haven't had oil on the air filter for 50k miles. I cleaned the ccv system when I first bought the vehicle. I have replaced the rear main seal, oil pan seal, oil filter adapter seal, valve cover casket, and they...

I have a 94 auto, btw.

Is there any solution for the leaky oil cap on a 4.0? I bought a new oem one, and that worked for a bit, then I tweaked the flanges to make it a little tighter, and that worked for a bit, but now it leaks a ton. Which brings me to another question. How much oil is it possible to leak out the...

The Quillomene/Colockum area near Vantage has lots of nice camping spots that require some moderate wheeling to get to. Some nice spots by the Columbia too. You need to get a green dot map and parking permit from the WSDFW.

Haven't had Internet access in the outback. Cap, rotor and plugs and then coil did the job.thanks!

Yep, 4.0. Original fuel filter. I have a coil,cap and rotor, and air filter, so maybe I should try those first? An aw4 wouldn't slip like that would it?

Just finished the White Rim trail yesterday, yeah! The car starting cutting out a little or stuttering heading out of Moab up the hill today, boo! Seemed to run fine downhill, but it has seemed a little underpowered lately. I checked the fuel pressure with and without the vacuum line attached...

The mini compressor fits great under the seat. Drilled a hole right next to it to run the lines outside.

All of a sudden my speedometer started showing a speed about 15% slower than the actual. I thought I had been driving a bit slow, then I bought a new GPS and that confirmed it. What would cause this to happen? I have a 94 auto six cylinder.

I bought the Nitro gears new from Just Differentials. They just looked like they were machined a lot better. The installer said they are made in Italy with Dana molds. I bought the Yukon gears from a private party, new and vacuum sealed in the box, who bought them from a friend at Randy's...

Recently had 4.10 gears installed. Nitro in the front and Yukon in the back. The Nitro gears are absolutely quiet, the Yukon gears are kind of annoyingly loud. Am I just stuck with a whiny gear or could the installer try to set them up again to run quieter?

I'm pulling an offroad trailer, so I need all of the turning radius I can get. I'll look up the WJ control arms, thanks. Maybe I will just go back to the 30's:0

I have a 3" lift with 31" tires on stock wheels. It's rubbing on the stock lower control arms pretty bad at full turn. If I replace the LCA's with aftermarket tube ones, from Iron Rock or Rusty's, would that completely solve the rubbing problem?

So what about a 1/2" steel lift block on one side? These guys have one ; http://www.rocky-road.com/xjshim.html