Recent content by MENEZES

I had a JCR front bumper and loved it. Personally, I don't like it but I'm not you so who cares. As long as mounts and hardware allow for operation under max shear capacity, your fine. Typically, adding plates to increase shear planes will increase shear capacity of bolts. You also want to use...

Pm sent

pm sent regarding rear tire carrier. Nick

I can come by for a little while. Anyone have a rear CV shaft they want to sell?

Hello! I have all 4 stock control arms (upper and lower) off a '95 Cherokee 4wd. They have about 170,000 miles but the bushings looked good except for some cracking. I replaced them with 4 RE arms. I need to get rid of them asap so hopefully someone can pick them up in San Jose this weekend...

Yeah, it is shorter by quite a bit actually. I have a 29 inch ZJ front driveshaft and it is too short. The 8.25/AX15/NP231 make for the longest distance between the rear output and the pinion. Sucks for me!

Hello! I am looking for a rear CV style drive shaft. I have a SYE kit waiting to go in but do not have a rear shaft yet. It is a 5spd with 4 inch lift and the 8.25. A stock xj front shaft will not work. I know that some ZJ's have something like a 33 inch collapsed CV shaft but I have yet to...

Wish I could go wheeling but family time has priority and I am stuck in the bay area. For those who share the same fate of hanging around the bay area, July 3rd at Shoreline in Mountain View, my wife's parents church is holding a July 4th 'Celebrate America.' Live music, food, car show...

The Crazies!

Front extended brake lines! Aftermarket or junkyard, does not matter to me.

Did you sell those drop brackets?

Everything is back up and running! Thank you.

If you do decide to install your self might I suggest visiting AccuAutoparts.com. That is where I bought everything I needed for my installs. Since you are all ready in your diff you might as well replace as much as you can afford. Setting up gears is hard but you can do, anyone can as long one...

I may be able to help. I installed 4.56s in my old 8.25 and Dana 30. Do you have a bearing press? Makes life easy. When were you planning on doing this? Let me know and I will check my school schedule.

pm sent!