Recent content by jlmxj49

Has anybody here had any experience with Crown or Omix-ada steering knuckles? I don't want to shell out for new Mopar's, but don't want junk either. Might be interested in buying some good used ones and weld up the brake pad divots, but would rather buy the new ones if they're any good.

Thanks guys. I'll check it out.

So I took apart the replacement switch I bought just to see if soldering was defective as mentioned in the video. I can't see anything wrong with any of the soldering. Also, the little arms are making contact with the little pads so the connection is being made there. I can see some of the...

First off, I did a search, read through some threads but didn't find this particular issue. I have an 01 Sport that I'm having a power door lock problem on. I can unlock all of the doors from both sides, but can't lock them with the drivers side master switch. I can lock them from the passengers...

Dang! I didn't even think about that. That should work. I'll look for some tomorrow.

So after putting it off for several years, I finally pulled the dash on my 2001 Cherokee to replace the bad evaporator core heater core, and old fan motor. The foam that is stuck on the top and ends of the core are good. Actually, I can peel them off and glue them to the new core. The problem is...

I also have a 2001 Cherokee with a rattle in the front suspension I've been chasing. I bought this thing a few years back with 132,000 miles and now I have around 187,000. I haven't drove it for the last year or so because it needed some work done, but before I stopped driving it, I noticed some...

By the way, that same site now shows it as discontinued.

So last night I went to the Mopar parts site RCP Phx linked to and ordered a windshield molding. This morning I got an email from them saying the item was no longer available and they issued a refund. There are several websites like this and some list it as not available, some do not. If any of...

To the first individual, I was not asking where to buy it! I'll just leave it at that. Anyway, I would much rather have the original Mopar molding, but was under the impression it was unavailable now. About 3 years ago I was looking for one and all I could find that any place stocked was one...

Who makes the best windshield rubber molding for a 2001 Jeep Cherokee? Crown or Omix?

Have any of you used these brackets in the link? Just wondering how they fit and if there were any issues with bolt holes/nuts lining up with the seat tracks.

2001, Cherokee Sport, and thanks for the link.

So I finally got around to putting in a new drivers side front floor pan since mine is rusted out. I bought the pan 3 years ago but kept putting it off. Had a leak for apparently a long time. Floor pan rusted really bad. Anyway, it got as far back as the riser that the front of the seat tracks...

The leaf springs on my XJ are not factory. There's a sticker on one of them that says Triangle Spring and a part number. A previous owner obviously pulled something with it because the springs have a helper spring at the rear of each leaf and a receiver hitch. The springs are pretty much flat...