Recent content by JKennedy

I don't see any studs on the case anywhere. My seloniod box has one red wire that goes to the battery, and three black wires that all run to three studs on the motor.

I bought it at a yard sale, and I was wondering where the ground attached from factory. Would a ground cable running from the winch mounting bolt to the battery work? It works when wired like that.

I have a Ramsey 9000Pro, and I was wondering how to properly ground it. My friend's Warn is grounded with a wire from the case of the winch motor to his battery. Mine didn't come with a ground wire. Are the bolts mounting it to my bumper good enough? -Thanks

I got my 8.25 from the junkyard with 4.10 gears, trac-lok, and 29splines, from a '00 4-cyl cherokee.

I know this is an old post, but did you ever sell these?

I used a pipe wrench on mine, after I messed up the threads with visegrips.

2-door or 4-door?

I'll could get away without it, and just change the seal, but I would rather not have to worry about it. Hopfully it'll get rid of that noise at 50 mph. Thanks for the advise, Jesse

Thanks, that sounds like what happened. I'm saving up for a SYE. That'll be the next mod. -Jesse

Yes, it's the stock driveshaft. I've had the lift for about a year. I wanted to do gears and get a stronger axle, so I got a 4.10 geared chrysler. From what I've found out by searching is that the chrysler 8.25 pinion is longer than the Dana 35, and that would push the driveshaft into the...

I have a 94 cherokee with a 5-speed and a N.P. 231. I just swapped my dana 35 for a '99 chrysler 8.25. After driving it for a day, with no vibrations, I have fluid leaking out of my slipyolk. At 50 MPH I can hear a ringing sound,but I really have to listen for it. I have 5 inches of lift and a 1...

Sent PM.

How much to ship the trackbar to 17362?

The welds on the nut for my shackle to frame bolt broke loose. What do I have to do?