• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by ingenio

  1. I

    Gearing

    4.88, do no hesitate. Truss the d30. Weak link are the ujoints and that's a 30min repair job on the trail. Install right speedo gear Enjoy
  2. I

    3" to 4.5 rear lift opinions

    x4.... extended shackles & HDO relocation bracket... off course you will need to address the SYE and other sh*t. good luck
  3. I

    Simplifying my 01

    bad grounds...bad grounds... check them all
  4. I

    Introducing our Ultimate XJ Steering Brace!

    Put in an order for a brace today. Looking forward to enhance my junk.
  5. I

    WTB OR-FAB Quarter panel w/Rail

    Hi guys, I would like to buy a set of ORFAB quarter panel armor with Rails for a 99 model. If you guys have a set for sale or know where I can buy a set (new or used) please let me know.
  6. I

    Yet another lift kit thread - OME vs Others

    Listen to md21722 ....well stated... Bilsteins are firmer than OMEs, but not bone jarring. I have used both. actually I have a set of Bilsteins 5100s for 3" lift never used...if interested please let me know. Bilstein ride is similar to a 2500 chevy pick up truck, and OME would be a 1500...
  7. I

    New cooling system overheating on the highway

    Dude, few years ago it was time to replace my old stock radiator & installed an Aluminum 3row radiator, and bling-bling 3 e-fan system that worked OK for a while... too expensive (efans, temp control units, custom shroud,etc,etc,etc) Due to the radiator dimensions, and the space from the...
  8. I

    WG knuckles with one inverted T tie rod and draglink?

    Hi dude, could you please share pics of your trackbar set up??....longer than stock, in front of the coil, coils centered in axle? thanks
  9. I

    Mild XJ build questions

    OMEs suspension (coils & leafs) and Bilsteins shocks in four corners for the best 2"lift and no larger than 30" tires....it may rub the rears when offroading for your intended use I would keep it stock and just to use Bilsteins ...dont need MT tires... for the AZ heat I would go with a...
  10. I

    HD 231 Shift Linkage (Auto Trans) from Boostwerks!

    Ordered a kit couple weeks ago. Just installed this past weekend, troublefree installation. Now I enjoy positive, smooth tcase gears shifts... A very cost effective solution so far. Will test the mechanism next weekend in the trails...will find out if flexing/twisting my junk may impact...
  11. I

    Bilstein Shocks for 5-6" lift

    Dude, i made the opposite mistake. Bought a set for a 4 lift and ended needing 5 to 6 ones, so we both are idiots but with different approach... Interested in swapping shocks?.. Bilsteins 5100 as well. Tomorrow I can send you Bilstein part numbers & extended and collapsed dimensions. Pedro
  12. I

    How to get 4.5" lift with loads of articulation?

    Remove the AAL ....it is too thick....wont flex at all I had the same problem with my OME set up I wanted 4.5 lift so I removed the AAL and installed longer than stock shackles and shackle relocation brackets Good flex and nice ride....sporty ride when paired with bilsteins..... Front I...
  13. I

    Ford HP D44 Housing, no inner C's

    Narrow or stock width? Donor?
  14. I

    outboard/extended trackbar mount

    This Blaine's design is just great...i have been planning the wj knuckles swap for months and just need to verify my clayton's long arms still have thread enough to adjust for the required wheelbase lenght increase
  15. I

    Best Gears For 31" Tires???

    The 8.8 comes in 4.10 flavor as well...and it is not unusuall to find them in the yj I intalled 4.10 w 265/75/16 and it's just OK, its an aw4 & 4.0 . A friend runs 31s with 4.56 and I really like it...noticeable increase in low end grunt and negligible real world mpg adverse impact....
See more
Back
Top