• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by GreenMachine1

  1. G

    New 4.5” Leaf Srings…Bushing Size Question???

    Happy Holidays!!! I just picked up a brand new set of Clayton Offroad 4.5” Leaf Springs for the XJ. I went to install them and before torquing everything down, I noticed a lot of play in the front bushing. The bushing sleeve inner diameter in the front is larger than in the rear. The front is...
  2. G

    New 4.5” Leaf Srings…Bushing Size Questio???

    Happy Holidays!!! I just picked up a brand new set of Clayton Offroad 4.5” Leaf Springs for the XJ. I went to install them and before torquing everything down, I noticed a lot of play in the front bushing. The bushing sleeve inner diameter in the front is larger than in the rear. The front is...
  3. G

    Gates Rubber Garbage

    Thanks for the clarification RCP.
  4. G

    Gates Rubber Garbage

    RCP, The K060935 has an effective length of 93.42" and the K060950 has an effective length of 95.02". The K060950 is listed for the 2000 XJ, and is what I have. I'm surprised K060935 fit your XJ.
  5. G

    Brand New Parts

    PM sent
  6. G

    Torque Converter Seating Dimension

    Thanks. I agree that all the service manuals I've seen say 0.650". I'd like to know what people are measuring on actual transmissions though. I should have taken a measurement before disassembling the transmission. Sent from my SM-N950U using Tapatalk
  7. G

    Torque Converter Seating Dimension

    Does anyone have a '97+ AW4 with factory converter available to check the dimension referenced in the attached AllData picture? I posted in the "Everything you need to know about AW4" thread but didn't get a response. The '97 and '00 FSM state the dimension should be 0.650" for 6 cyl and...
  8. G

    Everything you ever wanted to know about the AW4

    I took a look at the wear marks on the original pump inner gear from the 2000 xj and it looks like the drive lugs weren't fully engaged during operation. In one picture you can see the pump sitting flush on the TC with full lug engagement and in the other picture you can see the pump sitting...
  9. G

    A strange "fur-ball".....

    RCP, Do you mind sharing where you bought the IACs and the P/N? I am in process of putting together a motor for my 2000 and want to replace all sensors with new Mopar units. Thanks, Noah
  10. G

    Everything you ever wanted to know about the AW4

    Although I don't think this matters, I did use the pump body with gears and stator support shaft from the 97 donor trans as it was in better shape than the 2000 unit. To my knowledge, the pumps were the same for the A340 and AW4 from 1985 and up. The ATSG manual says the spec should be 0.689"...
  11. G

    Everything you ever wanted to know about the AW4

    Hi everyone! This is an extremely informative thread. Thanks to all who contributed. I recently picked up a very clean (for the Northeast) 2000 XJ Limited 2wd. The plan is to convert to 4wd so I set out to convert the 2wd AW4 to 4wd using a 97 4wd AW4 donor I had kicking around. I have...
  12. G

    DrawTite Trailer Hitch

    I'll ship at buyer's expense. I don't imagine this being very cheap to ship.
  13. G

    DrawTite Trailer Hitch

    DrawTite Trailer Hitch P/N 75054 I believe this fits 84 - 01 Cherokees. Hitch only. I do not have the wiring to go along with the hitch. $75 OBO Thanks, Noah
  14. G

    Factory Gas Tank Skid

    Factory gas tank skid off a 1997 Jeep Cherokee Country. Real good condition. Can text pictures. Not sure what this is worth. $100 OBO Thanks, Noah
  15. G

    Tera 2 Low kit with a wide chain

    RCP Phx, Looking good! Is that another stroker build for the second jeep or pictures from the previous build? Have any specs on all the studs? All from ARP? Keep up the good work and tech!
Back
Top