Recent content by Goat

Rear axle from a '85 F-350. BOM# is 605197-2. She has the OE Trac Lok and 4.10s. The Trac-Lok was refreshed by a previous owner and had approximately 3k miles in a street truck. 30 spline axle shafts but the spindles are large bore which means you can install 35 spline shafts without boring...

Sent ya PM.

Coolant temp gauge, shipped to 03054. I just broke off the spindle on mine, @#$%@#!

Does anyone have a schematic for the rear wiper motor on a '96? I'm installing a '96 liftgate onto my 89 and the 96 liftgate has a different drive circuit for the motor.

Paint color is not important. Header should be free of crack, broken studs or stripped screws. Send me a PM & the zip code I'd be picking up from. Thanks,

Sent ya a PM.

I'm looking for a passenger side rear door. Manual window & locks pre 97 XJ. Also looking for a hood from a pre 97 as well. Color doesn't matter. Let me know your asking price.

I have a set of doors from an 89 with power everything. The doors are junk but the regs & lock actuators are good Also have the glass if anyone is interested. The fronts have the vent windows. Just want to offset the cost of new doors so PM me an offer or if you want something else. Located...

4dr? I want the pass side rear door. Power/manual? Is the window rubber good, including run channels?

No, that wasn't me that you met in Pittsburg. Wish it was my truck though. To answer the question about lifting motor higher. My motor is as high as I can go with out having to hack apart the trans tunnel. If you can figure out & afford to dry sump it then that would gain you some room for...

I don't know about that...dry weight of a long block 4bt is 705lbs, per the factory.

With that much weight up front I wouldn't do a shackle reverse.

This is what a 4BT in an '89 looks like.

why do you need 50 tons?