Recent content by Doublehead

OK, then it's no problem. Thanks.

So it should just be the same as stock 4.0 bored 0.060" over?

I have a stroker with the Accurate Power piston rings. Does anyone know which piston rings I should use, the cylinders are bored 0.060" over. Thanks.

I just swapped in an '93-'94 Grand Cherokee engine into a '91 XJ. The old engine ran OK, no problem with that but the "new" doesn't run on all cylinders, maybe just 4. All cylinders do have compression and the spark plugs are new. The ignition is the same as on the old engine, almost new rotor...

How excactly does one fit a Toy case behind the AW4? Do you have to replace the trans output shaft, transfer case adapter, what else is needed? :)

yeah I know :) didn't realize there were MORE grounds then just the basic straps!!!

Found 3 wires right by the oil dipstick and grounded them, PROBLEM SOLVED!!! But I still have to reset the ignition... I must have put it 180 degrees off LOL

Any chance the sensors on the throttle body might be the problem?

All right, I just jumped the ASD relay (wire straight from 30 to 87), made no differance. Which leads me back to the crank sensor... but it's brand new, original Mopar!

Thanks for the advice, I found this on the ASD relay: So I was thinking about just grounding the relay permanently... or atleast try and replace it first and see if it helps...

Since my stroker engine has a Renix block but the rest is HO, where would be the best place to mount the ignition coil? The threads in the block are missing on the renix block...

What I mean with no fuel, is that the injectors aren't spitting any fuel inside the cylinder. And when I try to get a spark plug to spark I don't get any spark. It's just like the crank sensor is bad, but it's brand spanking new! I think there must be something causing the PCM to cut on spark...

Yeah I swapped the whole engine harness from the XJ to the YJ and it worked fine on the old engine... Right now the suspect is the ignition coil, next time I work on the Jeep I'm going to test if I can get a spark plug to spark with the wire from the ignition coil... if not I'm totally lost!

I have checked the grounds and replaced the battery, made no difference. I also changed out the crank sensor, no difference. What I'm now looking at is the sensor in the distributor but can't figure out HOW to get it out... :S

Yeah it's the '91 flexplate. Any chance I might have installed it wrong?