Recent content by David B

Email sent. Thanks Jeff!

1993 Jeep Cherokee 4x4 4.0L H.O., AW-4, NP231 TC w/ SYE kit, 117,000 mi., AC, CD, CB • Rusty’s air tube w/ K&N • Dynomax exhaust • New red top battery • Protofab winch bumper • Milemarker 8,000# winch • Ms. Conception Motorsports roof rack w/ tire carrier and hi-lift mount • Custom 4x4...

1993 Jeep Cherokee 4x4 4.0L H.O., AW-4, NP231 TC w/ SYE kit, 117,000 mi., AC, CD, CB • Rusty’s air tube w/ K&N • Dynomax exhaust • New red top battery • Protofab winch bumper • Milemarker 8,000# winch • Ms. Conception Motorsports roof rack w/ tire carrier and hi-lift mount • Custom 4x4...

What about Gauthier? I haven't seen a post (anywhere) from him in many many moons.

Re: CA: 1996 XJ, RE 5.5 XD, Ford 9" Detroit, HP D44 Electrac, 4.88, 35" MT's... Probably won't make it to Moab for the Fall Fling, huh? I would buy it from you in a heartbeat if only you were a little closer. Good luck. BTW, sweet Jeep.

PM sent.

Still have it? I may be interested. PM me.

Marc, Are you moving to Siberia or are you just bidding farewell to the XJ scene? Last time we wheeled, it seemed like your XJ was running fine except, of course, that whole four-wheels-off-the-ground trick in the rock Garden. I'll be there for the Fling, maybe even leading a trail as that...

I am looking to increase the performance of my tow rig. It is a '99 Chevy Tahoe with the 5.7L I have already purchased a conical K&N, removed the air filter casing cover and installed a magna flow muffler. I know nothing about chips and recently learned about some of the benefits of a...

Sold!!!

New Asking Price: $85 obo.

Here are some pictures of the bumper in "action". Someone make me an offer. http://community.webshots.com/photo/137956213/137975854bXlWbU http://community.webshots.com/photo/137956213/137979516UurktM

Check out this same post in the Intermountain Chapter forum for pictures of the bumper!!!

The bumper is stock and will fit an '84 to '96 Cherokee. It is reinforced on the inside at the bumper mounts with steel and then I welded (2) .25" steel plates to the outside on each side of the bumper. These plates are bent to follow the same curves of the bumper. The tire carrier brackets...

Sold!