Recent content by dave

the currie TREs look like one ton TREs till you notice they have to be custom because the thread on them fits thru a d30 knuckle with no reaming. there are no numbers of any kind on the currie TREs either and they wont give u a part number for em : \

the problem with fuel kind of sounds like you got crud on one of the wires coming off the fuel pump or something to that effect. did you visually inspect your allignment again? does it look off at all? when i had DW issues related to control arms angles i got it alligned.. made it home from...

i used manual seats out of a 95 xj that were in good shape.. the brackets were different however i just bent the ears on the brackets down.. reinforced the floor with some plate on the underside , threw neoprene covers on and viola ! super comfy compared to my old leather ! all i had to do was...

eric .. the currie setup is mega beefy.. its nice however the only pitfall is the TREs are custom and mega expensive from currie if you need a new one.. i've had this setup on 2 xjs and a tj and love it.. you will not be dissappointed... although you may have to do a bit of " clearancing" on the...

you say you want to see at night? you want bright ? get lightforce 9.5 inch 1,000,000 candle power lights.. i got em.. make the jeep look like mickey mouse but they are awesome .. waterproof with breather lines, different color lenses are swappable in about 15 seconds, bullet proof and...

Re: rear 60 i pm'd you back with my address and cell number.. i'll be home after 5pm.. gimme a call and let me know.

rockhound if you pay shipping sure ... either that or the longarms .. you decide.. just will have to wait to go till next week. i' m moving on friday but have off the week following so i can get it done.

i'm almost positive it does fill the tubes because i was reading a disc swap article on pirate about it and it stated to put a bucket under the axle when you pull the shafts because gear oil spill out.

ary reason being ... with the pinion rotated at an almost retarded angle i want to be able to get the gear oil fill line high enough to not make the pinion bearing and support bearing oil starved ( my d30 just went thru this , thank god i am ditching it soon )

for anyone who knows.... i want to get a heavy duty cover from bluetorch fab can you weld a fill plug into the diff cover on the top like alot of people do on ford 9" rears? or will the ring gear strike it? shaving the bottom.. can you just use the cover as a template?... anyone know the...

warren, nj .. its central jersey .. exit 40 off of rt 78 .. let me know.. it needs to be gone at the latest thursday night or its staying where its at.

Rear FF D60 4.10s , posi , big drums .. its the kind you dont have to remove the axleshafts to take the drums off. not cleaned off, original brackets .. i'm not taking this on my move.. its too heavy and my trailer doesnt like it. first person to call me and show up with $100 bucks takes it...

the lift itself it not a big deal to install. the center pics on the leaf springs will need to be massaged with a grinder to fit into the spring perch. the brakelines should be replaced with extended version, not hard but you will need to bleed the brakes, if you have never done an sye, and...

dana 44 is sold and gone.. ipf harness - awaiting funds everything is still available cage is now priced at 325 if you arrange shipping 350 if i have to.

its not that hard to mount, just make sure the shims are included with it. there is an aluminum block that needs to be taken out between the steering box and unibody in the front so one of the inserts can go there. the two mounting inserts also need to be ground down a little for it to fit right...