Recent content by CSThompsy12

Ill check out some local places... In past I have gotten windshields shipped no problem. I notice summit racing has them for most vehicles, wranglers etc, but no XJs. Right now I'm dealing with rust/pitting all along the windshield pinch weld surface. :smsoap:

I need a windshield for my 1998 XJ. I was looking to buy one online from a place like Summit Racing or similar, but so far I am having no luck. Anyone know of a source online?

Just wondering if anyone knows of a better door hinge pin kit. I used Dorman 38439. I would not recommend this one. I found it to be a poorly designed kit. After installation, It still had some play (sag) in the door, although it did improve somewhat. I noticed before I installed the kit...

I see Dorman sells a clockspring on Rockauto. Is that good? or should I go oem. The Jeep purrrs now.

Think I may have fixed it! I pulled the horn fuse and horn relay from the compartment down on the passenger side. This made the TPS % drop from about 69% to 18% in the idle position. So looks like it must be the clockspring that was throwing the voltage off? Its running well, however I had...

Yes, which must be why the scanner is reading a TPS percentage of 68% when the throttle is in the idle position? I have sort of ruled out the actual TPS being the problem.. I have tried the original one, a new Standard Motor brand one, and one off my other good running XJ, and they all read...

Did a couple more tests based on what you said, thank you... I unplugged the TPS and and put the meter the plug. Put black meter lead on the TPS ground terminal and red lead on center orange/black terminal (signal to PCM) and got 5.6 volts. Should that one have voltage with the TPS unplugged...

EDIT, not .2V on the center wire. It meant on the outside orange 5v supply wire.

Been doing some TPS testing, etc.. and I want to update where I'm at. I need expert help lol. I back probed the TPS connectors. I got the correct 5V across the ground network wire and the 5V supply wire (the two outside wires) Ohm'ed out TPS ground to battery ground. I then measured the...

Standard Motor Products brand off RockAuto. Not the cheapest one, not most $ either. I guess I could also take the one that is on my good running '99 Jeep and try it on this one I am having trouble with.

Thanks, I will definitely check this..

Hello, On my 98 XJ 4.0 I am having a TPS problem. I am getting a code for p0123 (High TPS voltage) I have put a new TPS on it, but that did not fix it. I put my scanner on it, and I am getting about 60% TPS position with the throttle on the idle position. I am getting the same with the...