• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by CowboyTex18

  1. C

    Cubby sub box build

    Sorry the finished picture looks wet I wiped it off with a damp paper towel. I also forgot to put that I coated it in beldiner to match the floors in the Jeep. Sent from my iPhone using Tapatalk
  2. C

    Cubby sub box build

    Sent from my iPhone using Tapatalk
  3. C

    Cubby sub box build

    Sent from my iPhone using Tapatalk
  4. C

    Cubby sub box build

    Sent from my iPhone using Tapatalk
  5. C

    Cubby sub box build

    Sent from my iPhone using Tapatalk
  6. C

    Cubby sub box build

    Sent from my iPhone using Tapatalk
  7. C

    Cubby sub box build

    Sent from my iPhone using Tapatalk
  8. C

    Cubby sub box build

    Hey guys I figured I would share my sub box I built over the weekend. I got tired of my big box for my 12” sub taking space so decided to build one in the useless cubby space. I didn’t take a ton of pictures but here is what I did take. Made it out of 3/4 MDF and graced it out of the cubby I cut...
  9. C

    Cheap 98 daily driver build

    I may at some point but not too worried about it right now lol. Sent from my iPhone using Tapatalk
  10. C

    Cheap 98 daily driver build

    Well I truly failed at keeping this updated like I had originally intended. I have done more work to this thing than I could even attempt to remember as far as preventative maintenance goes. Got wheels and tires as well as a lift on it. All new front end with heavy duty tie rod and adjustable...
  11. C

    What was done to YOUR rig(XJ/MJ) today MECHANICALY????

    Got the DIY bumper finished up and installed. Sent from my iPhone using Tapatalk
  12. C

    Best rust reversal/treatment products???

    I used chassis saver on my Jeep and loved it. Easy to put on. Came out smooth and dries super hard. Liked it better than POR-15 that I have used in the past. Sent from my iPhone using Tapatalk
  13. C

    Electrical issue with passenger blinker/brake light

    Welp it was ground 3030 on the seat mounting bracket. I tucked it behind the wires under the side trim whenever I cut the brackets and floorpans out and forgot to hook it back up. Hooked it up and everything is working lot it should! Sent from my iPhone using Tapatalk
  14. C

    Electrical issue with passenger blinker/brake light

    Well after doing more digging for the third day in a row I think I might have found the issue. I recently replaced floor pans and seat brackets and don’t think I reattached ground G303 back to the seat mounting bracket whenever I put them back in. Makes sense looking at the below diagrams. There...
  15. C

    Electrical issue with passenger blinker/brake light

    Do both lights ground on the driver’s side behind the panel where the tire carrier goes? I checked the grounds there. Not sure where else it would ground at. Sent from my iPhone using Tapatalk
See more
Back
Top