Recent content by ColoradoDave

NO!! Check your speakers first. check for ohm load and ground maybe touching metal intermittently while you're driving??

Alright, here's what's up..when a deck is in protect it means that either the ohm load to one or more of the speaker wires is too low or one or more of the speaker wires are grounding out. The easiest way to test this is with a test light or a meter and a 9V battery. pull your stereo and test...

Fan clutch is new, and the water pump is a couple years old..I thought about that too but would that affect the heat in the car?

Alright I've been searching for awhile now and I'm not finding what I'm looking for so here it is: 92 xj 4.0ho 5spd tons of miles ect. so long as I'm driving and my rpm's are up above say...1500 everything is peachy. my heat blows hot air my coolant temperature stays right at 210. no problems...

tons of weight can be stored up in the carpet too. There is tons of foam insulation under the carpet that stores up water adds lots of weight and causes rust. At the very least, pull the foam and insulation crap from under the carpet. you'll be amazed how heavy all that stuff is when you pull it...

Awesome thanks guys. The tools have arrived, and the seal came out without a problem. Not sure what I was stressin' about. Time to clean, clean, clean, and reassemble. Thanks again guys.

I've been reading write ups and threads for hours now and have one question still unanswered.. 92 4.0 with 5sp manual trans; I've read that with a 5spd I have to pull the tranny and I've also read that I don't. I've got my oil pan pulled off and I'm waiting for a friend to deliver some tools...

Hi. first off, 92xj 4.0 5spd np231, rustys 3 inch, 260k and still kickin. I've been chasing oil leaks for awhile and recently replaced the valve cover gasket and the oil filter adapter O rings. On the freeway yesterday I notice I'm burning oil and leaving a smoke trail thick enough to get lost...

your best bet is most likely lots of searching online, however, you're going to spend more money finding a factory keyless remote that works and you'll most likely have to pay the stealership to program it. I've been an installer at a stereo shop chain for about 5 years now and I have yet to...

What xm unit do you have? I'm assuming that since you're able to use it now through a headphone jack that it's a stand alone unit with a seperate display from the sony receiver? If this is the case then you will need an interface adapter that will allow your sony to dosplay and control your xm...