Recent content by bubba46

I mounted my straps from the UCA bolt to a bolt on the engine mount (frame side). You may need longer bolts on the UCAs. Sorry, no pics right now.

I know this may seem like a silly question... Can I use the 220v (3 phase?) behind the drier for a 220v single phase welder until an outlet is installed in the garage?

Doug, What are your thoughts on painting the "trim" in addition to the flares?

I'm working on planning out my wheel selection... what width and backspacing are you using? Thanks

Doug, Can you post the width of the flares again? How much wider than stock? Thanks.

I'll offer up the obvious: Dougn Extended Flares

As mentioned earlier, PM Doug if you're interested in participating in a pre-order. This will keep costs down by allowing him to buy material in bulk. It'll be great to see this product rolling.

I'd be interested in paying up front as well. Its about time a new flare option becomes avail to XJ owners and I'd be more than happy to help give it a jump start. The more sets produced the more visibility they will get that goes beyond NAXJA.

count me in!

Doug, we're rooting for you!

Doug, I know times are still tight but I thought a bump for an update would be in order. I'm still holding out.

I'm just itching to see another batch come out.

Doug, Please put me on your list for the next batch. I'm eager to get some flares on my XJ. -Dave

I've been trolling this post for some time trying to figure out which flares I'm going to install. After the previous pictures, I'm sold. Sounds like there is enough interest for another batch; hope you'll have some more out soon! Keep up the good work.

I have a LP D30 in my '00. Vibes started after a Rusty's 3" lift and stock LCAs. I didn't do anything about it and developed a leak in my front pinion seal over time. Now I'm at 4" and deeper gears so the vibs start at lower speeds (50-55mph). I know my pinion angle needs attention. If my...