Recent content by Blue xj 99

Still playing around to fine tune the pattern. The last 4 pics I posted seem to be the best it's going to get (with as backlash of 10). Nothing has really come close to that since. I was able to find a shop near me that is going to help finilize everything. I'll post final pattern and specs...

If you are taking about difference in backlash between the last comparison then all I did was move the thinnest shim from one side of the carrier to the other. Sent from my SAMSUNG-SM-N915A using Tapatalk

I didnt do any of those things. They are motive gears and I made set up bearings which is what I'm using now. Made sure to use the different carrier for the new gear ratio. Sent from my SAMSUNG-SM-N915A using Tapatalk

I'll try to get better pattern readings. Is the runout measured without any shims or with the amount of shims that are currently on the carrier? Sent from my SAMSUNG-SM-N915A using Tapatalk

What do you mean by run out? Sent from my SAMSUNG-SM-N915A using Tapatalk

If you guys could chime in that would be great. Jeeps been out of commission for a while and the gears are the last thing needed to get done. Sent from my SAMSUNG-SM-N915A using Tapatalk

Ok so two pics are with a backlash at 6 and the last two are at 9. Let me know which one is better. Sent from my SAMSUNG-SM-N915A using Tapatalk

Thanks for the advice. My pattern looks way better. This is the best I have gotten in a while. It looks close but I think it could be better. Let me know what you guys think and any suggestions. NRG= .05590 RG= .04165 Pinion= .0355, Add .0204 for the baffle Backlash= 10 Sent from my...

ok, so I get to fine tune my pattern and this is what I got. NRG= .0785 RG= .02055 BS=.008 Pinion shims=.059

Hello, Could I get some feedback one my gear pattern. Its a Dana 30 HP with 4.56 gears. Ill post backlash and shim specs later. Let me know if this looks good or if it can be better.